Parts List

Using your machine

Using the carpet washer

WARNING: The carpet washer has a constantly rotating brushbar. Never leave the carpet washer in one spot for an

extended period of time as this may damage the oor surface. To prevent any damage being sustained test on an

inconspicuous area of the ooring.

IMPORTANT: Your dirty water tank is tted with a oat. When the dirty water tank is full, or the oorhead is not in contact

with the carpet, the oat will shut o the suction on the carpet washer. You will be able to hear if this has happened as the

motor noise on the machine will increase. Once the oat is activated, empty the dirty water tank if full. If the dirty water tank

is not full then turn o your machine at the power switch and wait for the oat to settle.

NOTE: Carpets should be dry vacuumed thoroughly before washing. For heavily soiled areas, it may be necessary to repeat

the cleaning process. Make criss-crossing strokes across the original pattern and overlap with each pass.

Lift and pull to remove the

clean water tank.

Fill the clean water tank with warm water (max

40°C) to the water ll line. Pour the required amount

of Vax carpet cleaning solution to the solution ll line.

Twist the clean water tank

cap anti-clockwise

to remove.

TIP

For best cleaning results use slow straight

parallel strokes. Intermittent dry forward

strokes will increase water pick up.

Replace the clean water tank cap and twist

clockwise to tighten. Place the tank onto the

machine and push into place.

Plug into the mains, press the On/O pedal to

switch on. Press the recline pedal and pull

the handle backwards.

Squeeze the trigger to

release the solution and

water mix.

For best results apply water/solution on the forward

stroke and release the trigger on the backward stroke

to pick up water/solution. For a dryer nish, follow

with an additional dry stroke with no trigger pressed.