Vax V-124 User Guide v5.qxd 21/9/07 16:38 Page 1 Vax careline 0870 6061248 Vax model number: V-124 www.vax.co.uk instruction manual Carpet washer Please read carefully before using this cleaner. Always fully extend the mains cable before use. Retain for future reference.
Vax V-124 User Guide v5.qxd 21/9/07 16:38 Page 2 www.vax.co.uk 1. Diagram V-124 1 2 4 3 25 18 19 5 20 6 7 21 8 9 10 11 12 17 16 14 22 13 24 15 Fig.
Vax V-124 User Guide v5.qxd 21/9/07 16:38 Page 3 Vax Careline 0870 606 1248 2. Safety Information FOR HOUSEHOLD USE ONLY. When using the carpet washer, basic safety precautions should always be observed, including the following: 21. Using improper voltage may result in damage to the motor and possible injury to the user. The correct voltage is listed on the rating label. 22. A hazard may occur if the carpet washer runs over the power supply cord. 1.
Vax V-124 User Guide v5.qxd 21/9/07 16:38 Page 4 www.vax.co.uk 3. Assembly Attach Upper Handle Remove clean water tank (upper tank) from cleaner (Fig.3/1). Fig.3/1 Push bolts into holes on front of handle. If bolts will not go through hole easily, handle is not pushed completely down. Place nuts in recessed areas on back of the handle. Hold each nut in place while tightening each bolt securely (from the front of the handle) with a Phillips screw driver (Fig.3/4). Fig.
Vax V-124 User Guide v5.qxd 21/9/07 16:38 Page 5 Vax Careline 0870 606 1248 Attach Hose/Tool Caddy Storing Hose and Tools The hose/tool caddy is designed to be used either on the cleaner for easy access to the tools and hose, or if the tools are not going to be used, it can be removed and hung for storage. Press hose, a few centimetres from nozzle connector end, into caddy. Bring hose up and over top of caddy.
Vax V-124 User Guide v5.qxd 21/9/07 16:38 Page 6 www.vax.co.uk 4. Operation Before You Begin Cleaning Vacuum thoroughly - For carpet, use a Vax vacuum cleaner with an brushbar for best results. Vacuum upholstery with a vacuum cleaner with cleaning tool attachments. Use a crevice tool to reach into tufts and folds. Do not use the Dual V cleaner as a dry vacuum cleaner. For upholstery, always check the manufacturers guidelines before washing.
Vax V-124 User Guide v5.qxd 21/9/07 16:38 Page 7 Vax Careline 0870 606 1248 A AUTO RINSE WASH OFF Rinse ON Fig.4/5 Fig.4/7 The cleaner will no longer pick up dirty solution and the motor sound will become noticeably higher in pitch. When this happens, turn cleaner off and empty recovery tank before continuing use. Check clean water tank also; it may need to be refilled. Do not use without float and float retainer in place.
Vax V-124 User Guide v5.qxd 21/9/07 16:38 Page 8 www.vax.co.uk Fill tank (A) with warm tap water (Fig.4/10). Push the top of the tank and tank handle while supporting the back of the unit with your other hand (Fig.4/13). A Fig.4/10 CAUTION: Do not fill with water above 50°C. Fill solution container (B) with Vax Ultra Carpet/ Upholstery Solution (Fig.4/11). Fig.4/13 Push up on the handle once the tank is back to latch it to the unit (Fig.4/14). B Fig.
Vax V-124 User Guide v5.qxd 21/9/07 16:38 Page 9 Vax Careline 0870 606 1248 5. How to Clean Emptying the Recovery Tank Turn cleaner off and unplug from electrical outlet. Read “Before you begin cleaning” instructions on page 6. To prevent possible leaking, remove clean water tank by pressing down on tank handle and pulling forward; set tank aside (do not set tank on furniture). Fill clean water tank according to instructions for Fig. 4/8 to Fig. 4/10.
Vax V-124 User Guide v5.qxd 21/9/07 16:38 Page 10 www.vax.co.uk Continue using dry strokes until little water is visible passing through the recovery tank lid. ➡ ➡ ➡ ➡ ➡ ➡ For best results, use straight, parallel strokes. Overlap strokes by 3cm to help prevent streaking. Keep nozzle flat on floor for both forward and reverse strokes (Fig. 5/3). Picking Up Spills Your Vax Dual V cleaner may also be used to pick up small liquid spills on carpet or upholstery.
Vax V-124 User Guide v5.qxd 21/9/07 16:38 Page 11 Vax Careline 0870 606 1248 Plug solution tube firmly into solution connection port (B) (Fig. 5/7) 6. Accessories SpinScrub hand tool The SpinScrub™ hand tool has rotating brushes to agitate spots and stains. It is stored behind the tool door located on the front of the cleaner. To remove the tool, open tool door (Fig. 6/1). B Fig.5/7 To remove hose: Squeeze latches (C) on top and bottom of hose. Remove hose from port. Close door.
Vax V-124 User Guide v5.qxd 21/9/07 16:38 Page 12 www.vax.co.uk How To Attach Tools Unplug cleaner from electrical outlet. Place handle in upright position and remove hose from rack. All tools attach to the hose in the same manner: Connect tool to hose by sliding it onto connector until until the tab (A) locks it securely.Using your thumb, push forward and up on the latch (B) to remove tool (Fig. 6/4). After Using Tool A Fig.
Vax V-124 User Guide v5.qxd 21/9/07 16:38 Page 13 Vax Careline 0870 606 1248 A Place handle in upright position. Brushbar brushes will not rotate while handle is in upright position. Fill clean water tank according to instructions for Figs. 4/8 to 4/10. Fill solution container with Vax Ultra Solution according to instructions for Figs. 4/10 to 4/11. B Attach tool to end of hose. Do not point tools toward people or pets. Fig.6/7 Lift tool, and position it against riser.
Vax V-124 User Guide v5.qxd 21/9/07 16:38 Page 14 www.vax.co.uk NOTE: Make no more than 2 passes with the solution or rinse over any one area to prevent over-wetting and damage to fabric. If additional cleaning is necessary, wait until the upholstery is completely dry before using the tool again. Empty recovery tank when the motor sound becomes higher pitched and there is a loss in suction (see “Automatic shut-off”, Fig. 4/5).
Vax V-124 User Guide v5.qxd 21/9/07 16:38 Page 15 Vax Careline 0870 606 1248 Vacuum thoroughly after carpet has completely dried. This will help reduce any shading left by the cleaner’s brushes. To Clean Nozzle If lint or other debris becomes lodged in nozzle, it can be removed for cleaning. Unplug cleaner from electrical outlet. Remove both tanks as described in Fig 4/9 & Fig 4/10. With handle in upright position, tilt cleaner back so that handle rests on the floor. Lift up rear edge of nozzle.
Vax V-124 User Guide v5.qxd 21/9/07 16:38 Page 16 www.vax.co.uk B D A 8. Storage B Before Storing: A Empty clean water tank and let air dry. Replace on cleaner. Unused solution can be stored in the solution container. C Fig.7/7 Empty recovery tank, rinse tank and lid thoroughly with clean water and let air dry. Allow brushes and underside of cleaner to air dry thoroughly before storing cleaner on a carpeted or wood surface. Do not store cleaner with a full clean water tank in place.
Vax V-124 User Guide v5.qxd 21/9/07 16:38 Page 17 Vax Careline 0870 606 1248 9. Troubleshooting WARNING: To reduce the risk of personal injury, ! unplug the vacuum cleaner before performing maintenance or troubleshooting checks. PROBLEM: Solution won’t dispense. Cause: Solution: Valve cap clogged. Remove and clean valve cap. Cause: Solution: Solution switch is turned off. Turn the solution switch on. PROBLEM: Vacuum cleaner won't run Cause: Solution: Not properly plugged into electrical outlet.
Vax V-124 User Guide v5.qxd 21/9/07 16:38 Page 18 www.vax.co.uk 10. UK Service & Help Vax Care 0870 6061248 Monday-Friday 8.00am to 6.00pm. Saturday-Sunday 9.00am to 5.00pm. 11. Technical Specification Voltage: Wattage: Capacity: 220-240V ~50Hz W Clean water tank - 3.7 litres Dirty water tank - 2 litres Dirty water tank filter m kg An answerphone will be available out of these hours. Any queries or concerns about using your Vax, call the Vax Careline. Calls are charged at the UK national rate.
Vax V-124 User Guide v5.
Vax V-124 User Guide v5.qxd 21/9/07 16:38 Page 20 EEC STATEMENT OF COMPLIANCE Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility, declare that the product V-124 Dual V is manufactured in compliance with the following Directives: Safety: 2006/95/EC Low Voltage Directive EMC: 2004/108/EC Electromagnetic Compatibility Directive Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
