User Manual

PLEASE READ ‘LET’S TALK SAFETY’ AT THE BEGINNING BEFORE USE
Getting started
Before you begin cleaning
• IMPORTANT: Carpets should be dry vacuumed thoroughly before washing
• Test for colourfastness – Wet a white absorbent cloth with the solution. In a small hidden area of your carpet/rugs/
upholstery gently rub with the dampened cloth. Wait ten minutes and check for colour removal or bleed with white
paper towel or cloth. If your carpet has more than one colour, check all colours.
• Test your carpet/rugs/upholstery – Run the carpet washer over a small hidden area. If no pile distortion occurs
continue cleaning.
• When using the carpet washer, basic safety precautions should always be observed.
• IMPORTANT: Only use Vax carpet solution. Using other solutions may cause excess foaming and may
invalidate your warranty.
• IMPORTANT: The clean water tank should only be lled with warm water (max 40°C). Filling the clean water
tank with hot/boiling water may damage your machine and invalidate your warranty.
• CAUTION: This is a powerful carpet washer, before plugging in make sure all controls are turned o also
hold carpet washer rmly when starting and during use.
To secure the upper handle screw and tighten
with a cross/at head screwdriver.
Stand base in upright
position and lower the
top section until it clicks
securely connecting on
to the base.
Slide handle down
onto unit until it clicks
securely.
Assemble the two lower handle screws and tighten
with a cross/at head screwdriver.
Assembling your carpet washer
TIP
When cleaning an entire room,
move furniture out of the area
to be cleaned. If the furniture
is too heavy to move, place
aluminium foil or wax paper
under legs. This will prevent
wood nishes from staining
your carpet. Pin up furniture
skirts and curtains.