User`s guide

2.5.6 HALT Command
The HALT command
is:
H<CR>
The HALT command does not halt the CPU. HALT causes the console to print the contents of the PC
when the
CPU is already halted (CTRL/P is used to halt the CPU).
2.5.7 Indirect Command
The indirect command
is:
@<file specification><CR>
The @ command loads and executes the indirect command file specified on the power-up sequence or by
the operator.
2.5.8 INITIALIZE Command
The INITIALIZE command
is:
I<CR>
The INITIALIZE command performs the following:
• Initializes the TU58 controller
• Initializes the internal machine constants
• Initializes the processor to a known state
• Generates new processor status longword (PSL)
•
Deposits starting address of first good 64 K bytes + 200 to SP
2.5.9 LOAD Command
The
LOAD command 'is:
L/[<qualifier>]<space><file specification>(CR>
The LOAD command reads data from the specified file on the console load device to main memory,
console microprocessor memory, or to the
WCS. If no qualifier is given with the command, then physical
main memory
is loaded.
LOAD qualifiers are shown in Table 2-7.
2-14