User`s guide

The autosizer program (EVSBA.EXE) sizes the system on which it is executed (under the diagnostic
supervisor in the console mode)
and passes the system configuration to the diagnostic supervisor with a
single command.
To execute the autosizer, perform the following procedures:
1. Load and execute the autosizer in its self-test mode by typing the following commands:
DS>SET FLAG QUICK
DS>RUN EVSBA/SECTION:SELFTEST
The autosizer is loaded and executed and produces the prompt: COMMAND? At this prompt,
type the following
command to instruct the autosizer to determine the hardware configuration
of the system. Then, pass this information to the diagnostic supervisor:
COMMAND? SIZE
The autosizer prints ATTACH commands as they are passed to the diagnostic supervisor
(Example 5-3).
AUTOMATIC SIZING PROGRAM.
CONFIGURATION FILE FOR SYSTEM.
COMPUTER GENERATED CPU TYPE 3 MICROCODE REVE LEVEL = xx
NUMERIC VALUES WITH A LEADING ZERO ARE ASSIGNED.
FILE VALID ONLY FOR STANDARD HARDWARE CONFIGURATION.
TIME IS dd-mmm-yyyy hh:mm:ss
***QUICK FLAG SET. NO CHECKS MADE FOR TERMINALS ONDZ11'S***
DEF I NE PROCESSOR ....................................... .
DS> ATTACH KA730 HUB KAO YES 03FF 0 0124 NO NO
! DEF I NE UN I BUS ADAPTERS ................................. .
DS> ATTACH DW730 HUB DWO
DS> ATTACH RB730 DWO DQA
DS> ATTACH R80 DQA DQAO
DS> ATTACH RL02 DQA DQA1
DS> ATTACH DMF32S DWO XGAO 760340 0300 05 NONE
DS> ATTACH DMF32A DWO TXA 760340 0300 05 0377 9600 INTERNAL YES
DS> ATTACH DMF32P DWO LCA 760340 0300 05 OTHER
COMMAND?
Example 5-3 Typical Autosizer Printout of a RL02/R80 Configured VAX-II /730 System
5-9