User`s guide

**** BEGIN VAX-11/730,725 AUTO TEST ****
VERSION x.x RUN TIME APPROXIMATELY 15:00 MINUTES
CPU PART TESTING STARTED
MEMORY TESTING STARTED
CPU PART 2 TESTING STARTED
FPA TESTING STARTED
RB730 TESTING STARTED
RL02 PART DQA1 TESTING STARTED
CPU PART 3 TESTING STARTED
R80 DQAO TESTING STARTED
RL02 PART 2 DQA1 TESTING STARTED
3:30
1 : 30
0:45
1 : 30
0:45
0: 15
4:00
0:30
PASSED
PASSED
PASSED
PASSED
PASSED
PASSED
PASSED
PASSED
PASSED
DMF32S
XGAO TESTING STARTED
RUN TIME
RUN TIME
RUN TIME
RUN TIME
RUN TIME
RUN TIME
RUN TIME
RUN TIME
RUN TIME
RUN TIME
RUN TIME
RUN TIME
0:30
1 : 00
0:30
0: 15
*FAILED*
DMF32A TXAO-TXA7 TESTING STARTED
DMF32P
LCAO TESTING STARTED
AUTO TEST COMPLETE - XGAO BAD - CALL FIELD SERVICE
**** END OF VAX-11/730,725 AUTO TEST ****
Example 7-7 Printout of an AUTO Mode Testing Sequence
on a RL02/R80-Configured System in Which an Error Was
Detected During Macrodiagnostic Testing
7.4
MENU MODE
MENU
mode is invoked for system testing by one of the following methods:
1. Automatically at the successful completion of AUTO mode
2. Manually with the console I/O mode command, T /M
3. Manually with the diagnostic supervisor command, CRD
PASSED
PASSED
In the first of the above methods, MENU mode is invoked once AUTO mode testing has successfully
completed.
In this method, MENU mode testing is started without operator intervention, but further
system preparation may be required if options are added to the minimum system configuration.
7-9