User`s guide

This command loads microdiagnostic section ENKBC from the microcassette.
INIT[IALIZE] - Initializes a WCS section. This command must be issued after a section
is loaded by the
LD command before tests are executed.
It is automatically executed in a DI SE or DI command.
Example: MIC>LD EHKBC
MIC>IHIT
X/C or X/U - Allows the remote diagnostic terminal to downline load a file into the console microproc-
essor memory (C for console memory) or WCS
RAM (U for microcode). It is never executed from a
console terminal.
DI[AGNOSE] - The microdiagnostic unitspecified is loaded and run. If no unit is specified, then testing
starts at the first test and continues to the last test.
DI [<keyword>]
Example: MIC>DI
The following keywords may be used to modify the command.
BO[ARD]
CO[HTIHUE]
SE[CTIOHl
PA[SS]
TErST]
SH[ORTEH]
BOARD <type> - This keyword loads and executes all nonoptional sections that are associated with
either the WCS,
DAP, CPU, FPA, MCT or IDC board types.
NOTE
This command is incompatible with the SECTION
and TEST keywords.
Example: MIC>DI BO DAP
Run those tests that exercise the DAP (M8394) board.
SECTION <section> - This keyword loads and executes the specified section from the microcassette.
Example: MIC>DI SE EHKBC
Load and execute the tests that are included in section ENKBC.
TEST <number> - This keyword executes the specified test from the currently loaded section.
Example: MIC>DI TE 3
Run test number 3 of the section that is currently in RAM memory.
Example: MIC>DI TE 3 5
Run tests 3 through 5 of the section that is currently in RAM memory.
CONTINUE - This keyword is used only after the TEST keyword. It executes the tests from the speci-
fied <number> to the end
of the currently loaded section.
Example: MIC>DI TE 8 CO
B-2