W90-RU Series User Guide v5 Q7.qxd:User guide 16/4/10 12:56 Page 1 User Guide Vax Careline: AU: 1300 361 505 NZ: 0800 800 900 Carpet Washer Get Cleaning... What’s your Vax’s model number? V C W R S 7 0 0 What’s your serial number? (Located on the base of the machine) – – – – – Note these down in case you need them in future. Please keep instructions for further use. www.vax.com.
W90-RU Series User Guide v5 Q7.qxd:User guide 16/4/10 12:57 Page 2 --- Machine MachineOverview Overview 1 7 2 3 10 CL EANING SOLUTION 4 7 5 9 8 6 Fig.
W90-RU & W89-RU Series User Guide v1.3.qxd:User guide 1/2/11 12:41 Page 3 --- General GeneralSafety SafetyInformation Information FOR HOUSEHOLD USE ONLY. 16. Keep the unit on the floor. When using the carpet washer, basic safety precautions should always be observed, including the following: 17. Do not attempt to remove blockages with sharp objects as they may cause damage. 1. Do not leave the carpet washer unattended when plugged in. Unplug it from socket when not in use. 18.
W90-RU & W89-RU Series User Guide v1.3.qxd:User guide ----- 1/2/11 12:41 Page 4 Operation Operation Assembly: Putting your cleaner together Insert middle frame to machine base (Fig 3/1). Operation ! IMPORTANT: Turn off when emptying and filling the tanks and performing any maintenance. Grasp the solution reservoir under the handle and press the handle release lever in (Fig 4/1). Fig.3/1 Insert one screw on either side of middle frame to secure (Fig 3/2). Fig.
W90-RU & W89-RU Series User Guide v1.3.qxd:User guide 1/2/11 12:41 Page 5 --- Operation Operation ! IMPORTANT: Maximum water temperature 50°C Fill the remaining space in the solution reservoir with warm tap water. Replace the measuring cap (Fig 4/4). NOTE: use only Vax Solution, using other cleaning solutions may cause excessive foaming. This may cause the float to shut off the cleaner prematurely. Using other cleaning solutions will invalidate your warranty. Fig.
W90-RU & W89-RU Series User Guide v1.3.qxd:User guide ----- 1/2/11 12:41 Page 6 Operation Maintenance (Keep your Vax as good as new) Emptying the dirty water tank NOTE: The float in your Rapide is located in the lid of the dirty water tank. It will shut off the suction when the dirty water tank is full. For best results use a smooth steady motion keeping the nozzle flat against the carpet.
W90-RU & W89-RU Series User Guide v1.3.qxd:User guide 1/2/11 12:41 Page 7 --- Operation Maintenance (Keep your Vax as good as new) While making sure the dirty water tank is resting on the base, place the rear of the tank into the base of the cleaner, push down on the handle until it latches. Cleaning the tank filter IMPORTANT: Do not use any detergents or boiling water to wash the filters. Vax recommends checking the filters everytime the dirty water tank is emptied.
W90-RU & W89-RU Series User Guide v1.3.qxd:User guide 1/2/11 12:41 Page 11 --- FAQs FAQs ! WARNING: To reduce the risk of personal injury, unplug the carpet washer before performing maintenance/troubleshooting checks. PROBLEM: The cleaner won’t run. Cause: Not properly plugged into electrical outlet. Solution: Plug in firmly. Cause: No electricity in electrical outlet. Solution: Check fuse or breaker. Cause: On/off switch not turned on. Solution: Push on/off switch to ‘on’.
W90-RU & W89-RU Series User Guide v1.3.qxd:User guide 1/2/11 12:41 Page 12 ----- Other OtherInformation Information Vax Service & Help Vax Careline: (AU) 1300 361 505 (NZ) 0800 800 900 Monday-Friday 8.30am to 5.00pm If you have queries or concerns about using your Vax, call the Vax Careline. Calls are charged at the standard local rate. Please make a note of the serial number and model number of the vacuum cleaner before calling.
--- Notes 10 Vax Service line AU: 1300 361 505 / NZ: 0800 800 900
U91-MA Mach Air Series User Guide.qxd:User guide 9/7/09 09:54 Page 12 --- Distributed by Techtronic Industries Pty. Ltd. Level 1, 660 Doncaster Rd, Doncaster, Australia 3108. www.vax.com.au.
