Specifications

31
Caveats for Cisco IOS Release 12.0
78-6455-12
Resolved Caveats—Cisco IOS Release 12.0(12)
CSCdr16095
This defect provides ATM Signalling Control Plane Failure Detection through signalling diagnostic
MIB objects so the Network Management Station can monitor and take appropriate corrective steps
in erroneous situations. There is no workaround.
CSCdr53700
You may see the message "%ALIGN-3-SPURIOUS: Spurious memory access ..." when Microsoft
callback is being used and a callback fails to complete. The stack trace indicates the alignment error
occurred in the dial_if() function, called from dialer_enable_timeout().
There is no workaround.
CSCdr77993
A Cisco 2600 series router running Cisco IOS Release 12.0(11.6) reloads when a call connects with
Multilink PPP configured on Dialer Interface. There is no workaround.
CSCdr87607
When you load system software to upgrade from any version of the following Cisco IOS releases:
11.1 CC, 11.1 CA, 11.2 P, or 12.0 to any Cisco IOS Release 12.1 or later, the system logging
messages for Frame Relay DLCI and subinterface status change are suppressed, regardless of the
logging destination (console, buffer, or host).
Workaround: To resume generating Frame Relay DLCI logging messages, issue the logging event
dlci command. To resume generating subinterface status messages, issue the logging event subif
command.
Resolved Caveats—Cisco IOS Release 12.0(12)
All the caveats listed in this section are resolved in Cisco IOS Release 12.0(12). This section describes
severity 1 and 2 caveats and select severity 3 caveats.
Basic System Services
CSCdm91180
If you use hardware compression and fancy queueing with two simultaneous traffic streams (for
example, FTP and Telnet), packets are not compressed. Entering the show compress EXEC
command will not provide any useful information. There is no workaround.
CSCdp31382
IP Security (IPSec) configured with fast switching works only on serial interfaces and fails on other
types of interfaces. There is no workaround.
CSCdp81754
A Cisco AS5300 access server reloads with a bus error at PC 0x6022A3C8. This situation occurs
during an attempt to telnet to a named-host. There is no workaround.