Specifications

97
Caveats for Cisco IOS Release 12.0
78-6455-12
Resolved Caveats—Cisco IOS Release 12.0(5)
CSCdk92265
If online insertion and removal (OIR) is performed on a DMM card, autoselect fails. There is no
workaround.
CSCdk93438
A VIP controller on a Cisco 7500 series router might hang when encryption is used. This condition
is intermittent.
Workaround: Reload the router.
CSCdk93483
If voice traffic is process-switched (for example, when using RTP Header Compression), the
execution of certain EXEC commands on the router (for example, the
show running-configuration command), can have an adverse effect on the quality of voice calls
during the execution of the command when it is competing with voice packets for CPU time. There
is no workaround.
CSCdm01005
Committed Access Rate (CAR) fails to forward traffic when fragmentation is required and fast
switching is in use.
Workaround: Disable fast switching.
CSCdm03148
If you have a Cisco 7513 router with up to six channelized T3 cards, with many serial interfaces,
and you have recently upgraded from Cisco IOS Release 11.1(21)CC2 to Release 11.1(23)CC, the
copy run start command might take longer to execute, and performance problems might occur
with the router. SNMP responses can be noticeably slowed, and serial lines can see a line protocol
drop. This condition occurs when DCEF is enabled globally, but disabled on the VIP2 interfaces.
Workaround: Remove CEF from the router, or remove CEF distributed and apply IP CEF. You can
also enable DCEF.
CSCdm04449
OAM TX might be dropped.
Workaround: Use a release of Cisco IOS software that is older than the following releases:
Cisco IOS Release 11.3(05)DB0.3, Cisco IOS Release 11.3(06.06)DB0, Cisco IOS
Release 12.0(2.4), Cisco IOS Release 11.3(7.2)AA, Cisco IOS Release 12.0(2.4)T, Cisco IOS
Release 12.0(2.5)S, Cisco IOS Release 11.1(23.02)CC, Cisco IOS Release 12.0(2.5)PI, or
Cisco IOS Release 12.0(02.05).
CSCdm06832
A Cisco 1700 series router might inadvertently reload with SegV exception. There is no
workaround.
CSCdm07890
A relay IP address is not correctly completed when you configure DHCP proxy under virtual
templates. There is no workaround.
CSCdm08139
If Cisco a router runs Cisco IOS Release 11.3(8)T1 56-bit Encryption, and is configured to run
IPSec over Frame Relay, a point-to-point interface fails. The packets from the source IP address are
dropped when the router configured for IPSec. There is no workaround.