VS_19TL_Artwork.qxd 3/5/06 17:26 Page 2 Vax Careline: 0870 6061248 www.vax.co.uk BAGLESS UPRIGHT VACUUM CLEANER Vax Model Number: VS-19TLT Instruction Manual Please read carefully before using the cleaner. Always fully extend the mains cable before use.
VS_19TL_Artwork.qxd 3/5/06 17:26 Page 3 Parts Overview 1. Diagram FRONT BACK 20 18 11 20 20 9 10 19 2 11 18 17 8 12 3 7 16 4 13 5 14 6 Fig.
VS_19TL_Artwork.qxd 3/5/06 17:26 Page 4 Safety Information 2. Safety Information FOR HOUSEHOLD USE ONLY. When using the vacuum cleaner, basic safety precautions should always be observed, including the following: 1. Only use the vacuum cleaner indoors on dry surfaces. 2. Turn off the vacuum cleaner controls before connecting to or disconnecting from the mains supply. 3. Always unplug the vacuum cleaner before connecting or disconnecting the vacuum hose. 4.
VS_19TL_Artwork.qxd 3/5/06 17:26 Page 5 How to Assemble / How to Operate 3. How to Assemble IMPORTANT: Always unplug the vacuum cleaner from the electrical outlet before assembling or removing the accessories. 1. Place the base of the cleaner so it is facing away from you. Position the body so that the lower hose is on your right hand side. Push the body down into place.
VS_19TL_Artwork.qxd 3/5/06 17:26 Page 6 Accessories/Dirt Container & Filter: Removal & Replacement/Belt or Brush removal and replacement Empty all of the dust and dirt from the dirt container (fig. 6/1). 5. Accessories 1. Make sure the vacuum cleaner has been switched off and is in an upright position. Remove the lower hose by twisting clockwise and pulling away from the base of the cleaner. Remove the hose from the tool holder.
VS_19TL_Artwork.qxd 3/5/06 17:26 Page 7 Troubleshooting 8. Troubleshooting WARNING: TO REDUCE RISK OF PERSONAL INJURY UNPLUG VACUUM CLEANER BEFORE SERVICING PROBLEM: Cleaner won’t run Cause: Not properly plugged into electrical outlet. Solution: Plug cord in firmly. Cause: Blown fuse or tripped beaker. Solution: Check fuse or breaker. Replace fuse/breaker PROBLEM: Cleaner won't pick up/loss of suction Cause: Lower hose not connected properly. Solution: Refer to page 3 for fitting information.
VS_19TL_Artwork.qxd 3/5/06 17:26 Page 8 Uk Service & Help/Technical Specification 9. UK Service & Help Vax Care 0870 6061248 Monday-Friday. 9.00am to 5.00pm. An answerphone will be available out of these hours. Any queries or concerns about using your Vax, call the Vax Careline. Calls are charged at the UK national rate. Please make a note of the model number and serial number of your Vax before calling. There are over 400 approved Vax Service Agents in the UK.
VS_19TL_Artwork.qxd 3/5/06 17:26 Page 1 EEC STATEMENT OF COMPLIANCE Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility declare that the product VS-19TLT Turboforce Lite is manufactured in compliance with the following: Safety: 73/23/EEC Low Voltage Directive, as modified by 93/68/EEC EMC: 89/336/EEC Electromagnetic Compatibility Directive, as modified by 93/68/EEC Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
