User guide

assembly

3. How to Assemble

IMPORTANT: Always unplug the vacuum cleaner

from the electrical outlet before attaching or

removing the accessories.

Tool required: Crosshead screwdriver

1. Place the base of the cleaner so it is facing away from

you. Position the body so that the lower hose is on your

right hand side. Push the body down into place.

To secure the body in place insert two long screws

(supplied) into the back of the cleaner, through the hole

located above the hose guide (Fig.3/1).

2. With the cord clip on the handle facing you place it onto

the top of the body of the cleaner (Fig.3/2).

3. Push down firmly and line up the hole on the rear of the

handle. Insert lock piece into hole and screw into place

with the short screws (Fig.3/3).

4. Using the handle attach the main hose into the left

hand side of the cleaner. Press down firmly to secure in

place. The main hose can then be secured in the top and

side of the hose holder.

Place the dirt container lid onto the dirt container and turn

in a clockwise motion. Attach dirt container onto the

cleaner. The canister lid will snap into place in the body of

the cleaner.

Attach the tools to the tool holder. The dusting brush fits

over a post at the back of the vacuum cleaner.

The crevice tool fits into the extension wand. The

extension wand is located on the right hand side (Fig.3/4).

5. Store the TurboTool in the caddy on the handle, and

slide over the handle (Fig.3/5).

Crosshead screwdriver required

Fig.3/1

Fig.3/2

Fig.3/3

Fig.3/5

Fig.3/4

Back of

unit

vax.co.uk

U87-VU-PP User Guide- 28.02.13_UG 28/02/2013 14:40 Page 4