User guide

7
clearing blockages / troubleshooting
8. Clearing Blockages
WARNING: To reduce the risk of injury from
moving parts, unplug before servicing.
Clearing Blockages from the TurboTool
1. Turn the TurboTool over and slide off the locking-ring
(Fig.8/1).
2. Pivot lower housing and remove clog (Fig.8/2).
3. To re-assemble, ensure that the tabs are aligned and
pivot the lower housing closed. Slip the locking ring into
the groove at the neck of the TurboTool to complete
reassembly (Fig.8/3).
9. Troubleshooting
WARNING: To reduce the risk of personal injury,
unplug the vacuum cleaner before performing
maintenance or troubleshooting checks.
PROBLEM: Vacuum cleaner won't run
Cause: Not properly plugged into electrical outlet.
Solution: Plug in firmly.
Cause: Blown fuse/tripped breaker.
Solution: Reset circuit breaker or replace fuse.
Cause: Thermal cut out.
Solution: Refer to page 3 for information.
PROBLEM: Cleaner won’t pick up/loss of suction.
Cause: Lower hose not connected properly.
Solution: Refer to page 4 for fitting information.
Cause: Dirt container not installed correctly, or full.
Solution: Check dirt container is installed; empty if full.
Cause: Broken or worn belt.
Solution: Replace the belt.
Cause: Clogged filters.
Solution: Remove, clean and replace filters.
Cause: Nozzle/hose or hose inlet is clogged.
Solution: Remove nozzle/hose and obstruction.
PROBLEM: Dust escaping from the vacuum cleaner.
Cause: Dirt container full.
Solution: Empty dirt container.
Cause: Dirt container not installed correctly.
Solution: Check dirt container is installed; empty if full.
Cause: Hose not installed properly.
Solution: Check vacuum cleaner assembly.
!
L
OCK
ING
RING
Fig.8/1
Fig.8/2
TABS
Fig.8/3
!
Vax Careline: (UK) 0844 412 8455 (ROI) 1-800 928 308
U87-VU-PP User Guide- 28.02.13_UG 28/02/2013 14:40 Page 7