U90-M3 & M4 Series User Guide v1.4.qxd:UG 15/7/10 15:36 Page 1 Vax Careline: (UK) 0844 412 8455 (ROI) 1-800 928 308 Vax model number: U90-M3 series U90-M4 series WARNING: This cleaner has a constantly rotating brushbar which, when left in contact with lino, parquet and other hard flooring could potentially cause some damage to the floor surface. ! NOTE: Vax recommends that you raise the height of the brushbar when using this cleaner on lino and hard flooring.
U90-M3 & M4 Series User Guide v1.4.qxd:UG 15/7/10 15:36 Page 2 vax.co.uk 1. Diagram U90-M3 / U90-M4 1 2 22 23 3 4 20 5 16 19 6 17 15 18 15 7 14 14 13 8 9 20 10 11 21 12 Fig.1/1 PLEASE NOTE: some parts may vary according to model. Please check inside flap of box for more details.
U90-M3 & M4 Series User Guide v1.4.qxd:UG 15/7/10 15:36 Page 3 Vax Careline: (UK) 0844 412 8455 (ROI) 1-800 928 308 2. Safety Information 15. Do not use without ALL of the filters in place. For Household Use Only 17. Keep vacuuming area well lit. When using the vacuum cleaner, basic safety precautions should always be observed, including the following: 1. Only use the vacuum cleaner indoors on dry surfaces. Do not handle the plug or vacuum cleaner with wet hands.
U90-M3 & M4 Series User Guide v1.4.qxd:UG 15/7/10 15:36 Page 4 vax.co.uk 3. How to assemble Press button at handle base and push handle all the way down (Fig.3/4). Attach Handle Grasp orange tie wrap and pull until the black plug comes out of the handle cavity (Fig.3/1). Fig.3/4 Adjusting Handle Fig.3/1 Hold plug with one hand; upper handle with the other hand. Push plug into upper handle, aligning with opposite end of plug and push firmly until you hear a snap or click (Fig.3/2).
U90-M3 & M4 Series User Guide v1.4.qxd:UG 15/7/10 15:36 Page 5 Vax Careline: (UK) 0844 412 8455 (ROI) 1-800 928 308 4. How to operate Carrying Cleaner B The cleaner can also be moved by using the carrying handle (Fig.4/1). Fig.4/3 A NOTE: The nozzle will not move into the adjusted position until the cleaner handle is lowered to the operating position. Fig.
U90-M3 & M4 Series User Guide v1.4.qxd:UG 15/7/10 15:37 Page 6 vax.co.uk B A Fig.4/5 As an alternative, you may use the hose and power hand tool for stair cleaning. Clean from bottom to top. NOTE: When using cleaning tools, the brushbar will continue to rotate. CAUTION: To avoid personal injury or unnecessary wear to carpet, and to prevent the cleaner from falling, always place it at bottom of stairs.
U90-M3 & M4 Series User Guide v1.4.qxd:UG 15/7/10 15:37 Page 7 Vax Careline: (UK) 0844 412 8455 (ROI) 1-800 928 308 5. Dirt container & filters: removal & replacement NOTE: Familiarise yourself with these home maintenance tasks as proper use and care of your cleaner will ensure continued cleaning effectiveness. Emptying the Dirt Container Empty the dirt container before the dirt reaches the fill line (A) (Fig.5/1). A Fig.5/3 Press dirt container door release button to latch dirt container door closed.
U90-M3 & M4 Series User Guide v1.4.qxd:UG 15/7/10 15:37 Page 8 vax.co.uk Remove dirt container as described above. Twist filter assembly counterclockwise. Remove assembly from dirt container (Fig.5/6). D B A C Fig.5/8 Cleaning the Final Filter Fig.5/6 IMPORTANT: Disconnect cleaner from electrical outlet. Do not operate cleaner without dirt container or filters in place. ! Dirt and debris can be cleaned from the filter assembly by brushing with the cleaner’s combination tool.
U90-M3 & M4 Series User Guide v1.4.qxd:UG 15/7/10 15:37 Page 9 Vax Careline: (UK) 0844 412 8455 (ROI) 1-800 928 308 6. Maintenance Replacing the Headlight To remove the hood, press handle release pedal and place handle in low position. Using a coin, turn the two slots (A) on either side of the hood as shown (Fig.6/3). Removing lens Disconnect cleaner from electrical outlet. Press handle release pedal and place handle in low position.
U90-M3 & M4 Series User Guide v1.4.qxd:UG 15/7/10 15:37 Page 10 vax.co.uk ! IMPORTANT: To check condition of brushes, disconnect cleaner from electrical outlet. Move edge of a card across bottom plate while turning brushbar (Fig.6/9). Fig.6/6 Grasp brushbar firmly and fit it into position by first sliding end opposite the belt into the rectangular slot (A) on side of cleaner. Fig.6/9 Pull other side of brushbar (B) into place (Fig.6/7).
U90-M3 & M4 Series User Guide v1.4.qxd:UG 15/7/10 15:37 Page 11 Vax Careline: (UK) 0844 412 8455 (ROI) 1-800 928 308 Remove brushbar including end plates (A) and discard. Inspect belt to ensure that it is in good condition. If belt is cracked, gouged or broken, replace it (see following section). To replace bottom plate, insert the four tabs on edge of bottom plate into slots on front of tool. Pivot bottom plate down and snap closed (Fig.6/15).
U90-M3 & M4 Series User Guide v1.4.qxd:UG 15/7/10 15:37 Page 12 vax.co.uk With flat sides of turbine retainers (A) pointing down, slide retainers into grooves (B) in tool housing and snap into place (Fig.6/18). 7. Clearing blockages ! IMPORTANT: Disconnect cleaner from electrical outlet before attempting to clear blockages. Low suction or pick up may be due to a blockage in the system.
U90-M3 & M4 Series User Guide v1.4.qxd:UG 15/7/10 15:37 Page 13 Vax Careline: (UK) 0844 412 8455 (ROI) 1-800 928 308 8. Troubleshooting ! WARNING: To reduce the risk of personal injury, unplug vacuum cleaner before servicing. PROBLEM: Cleaner won’t run A Fig.7/3 Reposition tube on back of cleaner, replace 5 screws. Checking Under Hood Cause: Solution: Not properly plugged into wall outlet. Plug in firmly. Cause: Solution: No electricity in wall outlet. Check fuse or breaker.
U90-M3 & M4 Series User Guide v1.4.qxd:UG 15/7/10 15:37 Page 14 vax.co.uk 9. UK Service & Help 11. Technical Specification Vax Careline: Voltage: 220 – 240V ~50Hz (UK) 0844 412 8455 Wattage: 1300W (ROI) 1-800 928 308 Capacity: 2.5L Monday-Friday 8.30am to 6.30pm. Saturday-Sunday 9.00am to 5.00pm.
U90-M3 & M4 Series User Guide v1.4.qxd:UG 15/7/10 15:37 Page 15 Vax Careline: (UK) 0844 412 8455 (ROI) 1-800 928 308 This page has been left intentionally blank.
U90-M3 & M4 Series User Guide v1.4.qxd:UG 15/7/10 15:37 Page 16 EEC STATEMENT OF COMPLIANCE Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility, declare that the U90-M3 Mach 3 series and U90-M4 Mach 4 series upright vacuum cleaners are manufactured in compliance with the following Directives: Safety: 2006/95/EC Low Voltage Directive EMC: 2004/108/EC Electromagnetic Compatibility Directive Waste electrical products should not be disposed of with household waste.
