Owner`s manual

DRAFT
2.5 Continuing the Installation
You are now ready to proceed with the installation of the
VAX 6000 Model 600 processors. As noted in Chapter 1, you
read only the chapters that apply to your installation.
• Upgrading a Model 500 or 600 System. Proceed to Chapter 5
(Installing the KA66A Processor) and Chapter 6 (Verifying the System).
• Upgrading a Model 300 or 400 System with +3.3V XMI. Proceed
to Chapter 3 (Upgrading a Model 300 or 400 with +3.3V: Removing the
+3.3V Power Inhibit Cable) and then to Chapters 5 and 6 (Installing
the KA66A Processor and Verifying the System).
• Upgrading a System without +3.3V by Installing an H9657-CX
Kit. Proceed to Chapter 4 (Installing the H9657-CX Kit) and then to
Chapters 5 and 6 (Installing the KA66A Processor and Verifying the
System).
• Upgrading a System with an H9657-CU Kit. See the VAX 6000 XMI
Conversion Manual for directions on how to convert the power system.
You can then refer to Chapters 5 and 6 of this manual to tell you how
to install KA66A processor(s) and verify the installation.
Preparing for the Installation (All Upgrades) 2–9