Owner`s manual

DRAFT
For system upgrades using the H9657-CX and H9657-CU kits,
restore power to the system by:
1. Plugging in the system power cord.
2. Pushing the circuit breaker on the AC power controller to the On
position. The AC power controller is at the bottom rear of the cabinet,
as shown in Figure 6–2.
For all upgrades, turn the upper key switch on the front control panel to
the Enable position. The lower key switch should be set at Update position.
The system should run self-test, as described in Section 6.3.
Verifying the System (All Upgrades) 6–5