Owner`s manual

DRAFT
6.7 Save EEPROM to Tape (Optional)
If your system has a TK50 or TK70 tape drive, save EEPROM
to the tape. This tape would be used in case the EEPROM
contents become corrupted and must be restored.
Example 6–9: Saving EEPROM to Tape
>>> SAVE EEPROM
1
Proceed with save to tape? (Y or N) >>> Y
2
?006B EEPROM saved to tape successfully
>>>
Put a blank cartridge in the tape drive, write-enabled. The following steps
save the contents of the EEPROM to tape:
1
Enter the SAVE EEPROM command (see
1
).
2
The console program queries you (see
2
). Enter Y to save the EEPROM
contents to tape. The console program then confirms that the save
operation completed successfully.
Label the cartridge and store on site. Leave the cartridge with the system
manager, in case EEPROM contents become corrupted and need to be
restored.
NOTE: Use this cartridge with this system only. Tapes are not transferable,
since the parameters saved are system-specific.
6–20 VAX 6000: Installing Model 600 Processors