Installation guide

Updating Firmware C-7
1
If you type just the command show without a device mnemonic, LFU
prompts for the device mnemonic. All the commands that require de-
vice mnemonic will prompt.
2
If you enter ? (or help) for the device, a table displays the syntax for
specifying devices. All the commands that require device specification
s
use this syntax. Note the use of wildcards. For example,
show kdm70* would display all KDM70 controller modules.
3
If you enter an exit command at the device prompt, LFU returns to
the function prompt for another command.
4
The most useful form of the command is show * which displays every
module in the system. Note in this example that the CPU and CIXCD
modules require updating. (In other words, the + means that the firm-
ware version on the CD-ROM is higher than the version on the mod-
ule.)
5
VAX 7000 systems do not support kn7aa and kzmsa. The following de-
vices show up in the display instead:
ka7aa0 + 1.10 E04
kfmsa0 5.06 A04