Installation guide

Unpacking and Assembling Cabinets 2-19
Do the following for all cabinets in the system:
1. Use an adjustable wrench to lower and adjust the leveler feet of a cabi-
net. A shipping bracket can also be used to adjust the leveler feet,
since the bracket cutout and leveler feet hexnuts are the same size. In
order for the cabinet skirts to be installed properly later, the leveler
feet must now be lowered sufficiently for the cabinet wheels to be off
the floor.
2. Use a bubble level while adjusting the feet and make sure cabinets are
properly leveled in three dimensions (top to bottom, side to side, and
front to rear). The operation is complete when all intercabinet bolt
holes are aligned. Bolt holes are located at the tops of the cabinets
and at the bottom door hinges of the cabinets.