Installation guide

Unpacking and Assembling Cabinets 2-21
1. Locate a top spacer in the installation kit. A top spacer is a short alu-
minum bracket that is installed horizontally between the tops of ad-
joining cabinets (see Figure 2-10).
2. Align the two sets of holes in the top spacer with the two sets of holes
in the tops of the frames of two adjoining cabinets.
3. Insert two 80 mm (3.15 in) long bolts from the installation kit (one bolt
per set of holes), position accompanying washers properly, attach ac-
companying nuts, and tighten.
4. Repeat 1 through 3 for each pair of adjoining cabinets.