Installation guide

Unpacking and Assembling Cabinets 2-33
1. Locate the DC power distribution box in the rear of an expander cabi-
net (see Figure 2-16). Remove the plastic cover of the battery cable
terminal block by unscrewing two nuts.
2. Observe the labeling of the battery cable terminal block. Connect the
+ and – leads of the cable pair labeled "A" (green label) to the top two
terminals labeled + and – (see Figure 2-16). Use a 13 mm socket
wrench or nut driver to tighten each connection (a maximum of 10 in-
lbs is recommended).
3. Connect the cable pairs labeled "B" to the center two terminals labeled
+ and – (see Figure 2-16).
4. Connect the cable pairs labeled "C" to the bottom two terminals la-
beled + and – (see Figure 2-16).
5. Replace the cover of the battery cable terminal block and secure it by
screwing in the two nuts you removed in step 1. The cover has a cut-
out in its left side through which the six battery power cables pass.
6. Plug the male 9-pin connector of the battery sense cable into the fe-
male 9-pin connector near the battery cable terminal block (see Figure
2-16).