Installation guide

Unpacking and Assembling Cabinets 2-39
1. Locate all front and rear doors you removed in Section 2.7.
2. To replace a door, first position the door so that the pin in the bottom
hinge is inserted into the corresponding hole at the bottom of the door.
3. Lift and position the door while depressing the spring bolt until the
bolt lines up with the hole in the top hinge.
4. Release the spring bolt to insert it into the top hinge.
5. Repeat 2 through 4 for all doors in the system.
6. Locate all cabinet tops and associated screws you removed in Section
2.6.
7. Replace a cabinet top by placing it on top of a cabinet so that the tab
faces the rear of the cabinet; then press down.
8. For system and expander cabinets, use the screw previously removed
from a top to reattach the top to a cabinet frame.
9. Repeat 6 and 7 for all cabinet tops in the system. See Figure 2-20.