Installation guide

Unpacking and Assembling Cabinets 2-43
1. Attach one end of the DSSI cable (BC21Q-06 or BC21Q-09) to the XMI
PIU bulkhead connector in the rear of the expander cabinet (see Fig-
ure 2-22). If necessary, install a terminator plug to properly terminate
this end of the DSSI cable.
2. Route the DSSI cable through the upper cable trough on the right rear
of the exapnder cabinet to the front of the expander cabinet. Now
route the DSSI cable to the topmost disk brick.
3. Attach the end of the DSSI cable to the connector on the left of the
disk brick in the top of the disk PIU. If only one disk brick is present,
attach a terminator plug to the other connector (see Figure 2-23).
4. If two or more disk bricks are present, use short jumper cables
(BC21Q-01) to daisy-chain the disk bricks (see Figure 2-23) on a single
channel. Install the jumpers and terminator as shown in Figure 2-23.
Figure 2-23 Cabling and Terminating Disk Bricks
One Brick
Single Channel
Two Bricks
Single Channel
Three Bricks
Single Channel
DSSI Cable
Terminator
Jumper
BXB-0342-92
For more information:
RF Series Integrated Storage Element User Guide