Installation guide

4-8 Connecting to a DSSI Subsystem

4.4 Cables

Each KFMSA module has two separate DSSI buses (ports) cabled

from the XMI backplane. The cable from XMI backplane section D

(upper section) is designated as bus 1, and the cable from section E

is bus 2. These cables connect to the XMI PIU bulkhead at a DSSI

connector.

Figure 4-3 I/O Ports for DSSI Cables

NOTE: For standalone systems with DSSI PIUs, node ID settings are fac-

tory set to 7 and require no change. For multi-hosts, reset node ID

settings as required.

I/O Panel

BXB-0073C-92

Off