V-026 Series User Guide.qxd:V-026 26/3/10 15:45 Page 1 Vax Careline: (UK) 0844 412 8455 (ROI) 1-800 928 308 Vax model number: V-026 series vax.co.uk instruction manual Carpet washer Please read carefully before using this carpet washer. Always fully extend the mains cable before use. Retain for future reference.
V-026 Series User Guide.qxd:V-026 26/3/10 15:45 Page 2 vax.co.uk 1. Diagram V-026 1 12 21 14 13 22 2 3 23 24 15 4 25 5 16 6 26 SOLUTION 9 7 19 17 10 20 18 8 27 11 Fig.
V-026 Series User Guide.qxd:V-026 26/3/10 15:45 Page 3 Vax Careline: (UK) 0844 412 8455 (ROI) 1-800 928 308 motor and possible injury to the user. The correct voltage is listed on the rating label. 2. Safety Information FOR HOUSEHOLD USE ONLY. 21. A hazard may occur if the carpet washer runs over the power supply cord. When using the vacuum cleaner, basic safety precautions should always be observed, including the following: 22.
V-026 Series User Guide.qxd:V-026 26/3/10 15:45 Page 4 vax.co.uk 3. Assembly Attach upper handle Stand the base in the upright position. Assemble the mid section onto the base, taking care not to trap internal mains wire. (Fig.3/1). ! Fig.3/4 Place nut into recess on hose/tool caddy and hold into place. Press handle release with your other hand to tilt the midsection backwards (Fig.3/5). Fig.3/1 1 2 Insert the two nuts into the recesses located on the left and right sides of the base.
V-026 Series User Guide.qxd:V-026 26/3/10 15:45 Page 5 Vax Careline: (UK) 0844 412 8455 (ROI) 1-800 928 308 Detach the hose adaptor from the end of the hose and slide it onto the adaptor post (Fig.3/8). Fig.3/8 Fit the wash tool into the middle slot of the hose/tool caddy (3/9). Wrap hose round the upper hose wrap, anti-clockwise, twice, ensuring the hose is secured in the hose clips (Fig.3/11). Fig.
V-026 Series User Guide.qxd:V-026 26/3/10 15:45 Page 6 vax.co.uk 4. Operation ! IMPORTANT: Turn off when emptying and filling the clean water tank. Filling the clean water tank Remove clean water tank from the carpet washer (Fig.4/1). NOTE: Use only Vax carpet cleaning solution, as other cleaning solutions may cause excessive foaming. This may cause the float to shut off the cleaner prematurely. Using other cleaning solutions will invalidate your guarantee.
V-026 Series User Guide.qxd:V-026 26/3/10 15:45 Page 7 Vax Careline: (UK) 0844 412 8455 (ROI) 1-800 928 308 Insert the hose adapter into the top of the dirty water tank (Fig.4/9). Fig.4/6 When the dirty water reaches the max fill line on the dirty water tank, empty the tank. Hose Attachments NOTE: DO NOT OVERSATURATE YOUR UPHOLSTERY. Fig.4/9 Connect the hose water supply plug into the socket on the lower left side of the cleaner (Fig.4/10).
V-026 Series User Guide.qxd:V-026 26/3/10 15:45 Page 8 vax.co.uk Carry Handle Grasp the handle on the back of the unit to move unit from room to room (Fig.4/12). Fig.4/12 Pull the dirty water tank up out of the base, taking care to ensure that no dirty water leaks from the front (Fig.4/14). Fig.4/14 Remove dirty water tank lid (Fig.4/15). NOTE: Do not transport the carpet washer with either the clean or dirty water tanks full.
V-026 Series User Guide.qxd:V-026 26/3/10 15:45 Page 9 Vax Careline: (UK) 0844 412 8455 (ROI) 1-800 928 308 Cleaning the Dirty Water Tank Rinse the dirty water tank and filter thoroughly with warm water. You should allow them to dry fully before replacing them on your cleaner to prevent mildew (Fig.4/17). NOTE: Failure to install the dirty water tank correctly will result in poor dirty water pick up.
V-026 Series User Guide.qxd:V-026 26/3/10 15:45 Page 10 vax.co.uk 5. Maintenance Lift brushbar while pulling it out (Fig.5/4). Belt or Brush Removal and Replacement Phillips screwdriver required ! IMPORTANT: Plug must be removed from socket outlet before cleaning or maintaining the appliance. Remove the water tank, switch off and unplug the carpet washer. Flip the cleaner on it’s side to expose the nozzle base. To remove the belt cover, use a phillips screwdriver to remove the two screws (Fig.
V-026 Series User Guide.qxd:V-026 26/3/10 15:45 Page 11 Vax Careline: (UK) 0844 412 8455 (ROI) 1-800 928 308 Separate the foam filter from the float (Fig.6/2). 6. Troubleshooting WARNING: To reduce the risk of personal injury, unplug the vacuum cleaner before performing maintenance or troubleshooting checks. ! PROBLEM: The cleaner won't run. Cause: Not properly plugged into electrical outlet. Solution: Plug in firmly. Cause: No electricity in electrical outlet. Solution: Check fuse or breaker.
V-026 Series User Guide.qxd:V-026 26/3/10 15:45 Page 12 vax.co.uk 7. UK Service & Help 8. Technical Specification Vax Careline: Voltage: Wattage: Capacity: (UK) 0844 412 8455 (ROI) 1-800 928 308 Monday-Friday 8.30am to 6.30pm Saturday-Sunday 9.00am to 5.00pm Any queries or concerns about using the Vax, call the Vax Careline. Please make a note of the serial number and For the nearest Service Agent, please call the Vax Careline. vax.co.
V-026 Series User Guide.qxd:V-026 26/3/10 15:45 Page 13 Vax Careline: (UK) 0844 412 8455 (ROI) 1-800 928 308 This page has been left intentionally blank.
V-026 Series User Guide.qxd:V-026 26/3/10 15:45 Page 14 vax.co.uk This page has been left intentionally blank.
V-026 Series User Guide.qxd:V-026 26/3/10 15:45 Page 15 Vax Careline: (UK) 0844 412 8455 (ROI) 1-800 928 308 This page has been left intentionally blank.
V-026 Series User Guide.qxd:V-026 26/3/10 15:45 Page 16 --- EEC STATEMENT OF COMPLIANCE Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility, declare that the Vax V-026 series carpet washer is manufactured in compliance with the following Directives: Safety: 2006/95/EC Low Voltage Directive EMC: 2004/108/EC Electromagnetic Compatibility Directive Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
