User Guide Vax Careline: AU: 1300 361 505 NZ: 0800 800 900 Workman Get Cleaning... What’s your Vax’s model number? V C C – 0 5 / V C C – 0 7 What’s your serial number? (Located on the base of the machine) Note these down in case you need them in future. Please keep instructions for further use. vax.com.
Vax Service line: AU: 1300 361 505 NZ: 0800 800 900 vax
505 900 Machine Overview VCC-05 & VCC-07 4 3 5 2 6 7 1 8 9 11 12 10 14 16 17 1 2 3 4 5 6 Hose inlet Top cover retainer clip Top cover Carry handle Power cord storage Parking slot vax.com.
General Safety Information FOR COMMERCIAL USE ONLY. 15. When using the vacuum cleaner, basic safety precautions should always be observed, including the following: Do not vacuum plaster dust, concrete dust or any other building or vitreous materials. 16. Do not vacuum baking soda or any other powder-based carpet refresher or deodoriser. 1. This appliance is for dry use only and is not to be used or stored outdoors or in wet conditions. 17.
05 900 Operation How to assemble Insert the flexible hose into the inlet on the main body of the vacuum cleaner. Turn the hose clockwise until it cannot be turned any further. Push the extension tube on Fit the combination floor to the end of the handle. head by pushing onto the The extension tubes can extension tube. be used together to lengthen or shortened by using one section of the extension tube as required.
Operation How to operate Fully unwind the power cord. Carpet Cleaning Hard Floor Cleaning On/Off Button For carpet and rug cleaning press the rocker switch on the combination floor head to raise the brushes. For hard floor cleaning, press the rocker switch on the combination floor head to lower the brushes. Insert the power plug into the electrical outlet. Ensure the vacuum cleaner is switched off.
505 900 Maintenance (Keep your Vax as good as new) Dirt container removal and replacement IMPORTANT: Always unplug the vacuum cleaner from the electrical outlet before removing the dust bag. IMPORTANT: DO NOT use the vacuum cleaner without ALL of the filters in place. Dust Bag Replacement Lift out the full dust bag Turn off the vacuum cleaner and unplug it from the mains. Remove the hose. Unclip the retainer clip on the top of the unit and lift up to gain access to the dust bag compartment.
Maintenance (Keep your Vax as good as new) HEPA Pre-motor filter (Model VCC-07 only) Turn off the vacuum cleaner and unplug it from the electrical outlet. Unclip the retainer clip on the top of the vacuum cleaner and lift up to gain access to the dirt container department. The HEPA pre-motor filter is found in the centre of the dirt container. Rotate the filter clockwise to remove. Gently tap the filter against the side of the rubbish bin to remove excess dirt.
505 900 FAQ’s WARNING: To reduce the risk of personal injury, unplug the vacuum cleaner before performing maintenance/troubleshooting checks. Problem Cause Solution Cleaner won’t run Not properly plugged into electrical outlet. Plug unit in firmly. Vacuum cleaner not turned on. Press on/off button. No electricity in the electrical outlet. Check fuse or breaker. Blown fuse/tripped breaker. Reset circuit breaker or replace fuse. Motor thermostat has tripped.
Other Information Vax Service & Help Vax Careline: Australia New Zealand 1300 361 505 0800 800 900 Monday-Friday 8.30am to 5.00pm If you have queries or concerns about using your Vax, call the Vax Careline. Calls are charged at the standard local rate. Please make a note of the serial number and model number of the vacuum cleaner before calling. For the nearest Service Agent, please call the Vax Customer Careline or visit vax.com.
505 900 Notes vax.com.
Distributed by Techtronic Industries Australia Pty. Ltd. Level 1, 660 Doncaster Road, Doncaster, Australia 3108. www.vax.com.
