User guide

4.4.3 Preparing the System Unit for an Expansion Box
To prepare the system unit for an expansion box, follow these steps:
1. Shut down the operating system using the procedure outlined in the
operating system documentation.
2. Set the on/off switch on the system unit to the off (O) position.
3. Remove the SCSI terminator as shown in Figure 4–1.
4. Move the terminator to the last open port on the SCSI expansion box.
4.4.4 Connecting the SCSI Expansion Box
Caution
You must complete the procedures outlined in the following sections
before you start the procedure in this section:
• Section 4.4, Connecting a SCSI Expansion Box
• Section 4.4.1, Guidelines for Connecting Expansion Boxes
• Section 4.4.2, Selecting Available SCSI IDs on the System
• Section 4.4.3, Preparing the System Unit for an Expansion Box
4–8 Hardware Options