User guide

Vax Service line: AU: 1300 361 505
NZ: 0800 800 900
7
Maintenance
(Keep your Vax as good as new)
Cleaning the Pre-motor and Post-motor lters
Storage
Cleaning the Post-motor HEPA Filter
NOTE: Vax recommends regularly cleaning the lters (depending on level of use) to optimise the
performance of the vacuum cleaner.
NOTE: Do not use any detergents or boiling water to wash the lters (max 40°C).
NOTE: Allow lters to completely dry before replacing back into the machine. We recommend
24hrs to dry completely.
Cleaning the Pre-motor Foam Filter
IMPORTANT: Always unplug the vacuum cleaner from the electrical outlet and rewind the power
cord as directed before storing.
NOTE: Always store the vacuum cleaner base down.
Remove the dirt container
as previously directed.
Remove the lters as
shown above.
Release the post-motor
cover by pressing in
the catch at the top of
the cover.
NOTE: This is located
at the rear of the vacuum
cleaner.
The pre-motor foam lter,
may be rinsed in luke
warm water (max 40°C).
Allow to thoroughly air dry
before replacing.
The post-motor HEPA lter can be removed and rinsed
in luke warm water (max 40°C). Allow to thoroughly air
dry before replacing (allow 24hrs).
Replace the post-motor HEPA lter back in the case
and return to the vacuum cleaner.
Replacement Filters
Replacement lters are available from your Vax stockist.
Phone VAXCARE or visit www.vax.com.au
Clean Cage Filter
Separate the lter assembly by removing the foam lter
from its plastic housing. Tap the foam lter on the inside
of a rubbish bin to remove excess dust and dirt from lter.