Installation manual

Using VMSTAILOR and DECW$TAILOR
10.2 Using DECW$TAILOR
4. Decide which file classes or subclasses you need to add. DECW$TAILOR
displays step-by-step instructions. Follow these instructions to specify which
of the classes or subclasses you want to remove.
5. DECW$TAILOR deletes the files you selected and displays the names of those
files. If you deleted device support files, the system automatically shuts down
and reboots.
Caution
To cancel DECW$TAILOR during the first and second phases, press
Ctrl/C, Ctrl/Y, or Ctrl/Z. Canceling DECW$TAILOR during the third
phase can cause a partially tailored disk.
For a description of each phase, see Section 10.2.1.
10.2.4 Adding DECwindows Files
To install DECwindows device support and font files after the OpenVMS VAX
installation or to add optional DECwindows files that you previously chose not to
install or that you removed, do the following:
1. Log in to the SYSTEM account.
2. Load the OpenVMS VAX distribution media containing the DECwindows save
sets in a drive available to your system. For example, if your distribution
media is a TK50 tape cartridge, load the second tape cartridge into a TK50
drive that is available to the system. Make sure the drive is on line and
ready.
If you are adding files from a compact disc on an InfoServer, first determine
whether the SYSGEN parameter SCSNODE is defined on your system
(see Section 5.5) or start the DECnet software, and then refer to step 2 of
Section 7.2 in Chapter 7.
3. Enter the following command, and press Return:
$ RUN SYS$UPDATE:DECW$TAILOR
DECW$TAILOR displays information about the DECW$TAILOR program,
and displays the following message:
Do you want to tailor files "ON" or "OFF"?
4. Type ON to add files, and press Return.
The DECW$TAILOR program lists each group, or class, of files and its size
in blocks. Files are grouped according to their function. For example, all the
files required for DECwindows device support are in one class. A file class is
made up of many small subclasses. You can add an entire class of files, or you
can add one or more of its subclasses. For example:
CLASS - DECwindows workstation support files
Size of entire class (with subclasses): 14301
Size of common files required for any subclasses: 8937
Do you wish to select the entire class (default = NO)?
.
.
.
10–8 Using VMSTAILOR and DECW$TAILOR