Installation manual

After Installing the OpenVMS VAX Operating System
4.13 Postinstallation Checklist
4.13 Postinstallation Checklist
Use the following checklist to make sure you perform all the necessary
postinstallation tasks.
Verify the system time. (Described in Section 4.1)
Register your licenses if you did not do so during the installation procedure.
(Described in Appendix B of this manual and in the OpenVMS License
Management Utility Manual)
Build a standalone BACKUP kit on the system disk and on removable media.
(Described in the upgrade and installation supplement for your computer)
Back up the system disk as a safeguard before customizing the system.
(Described in the upgrade and installation supplement for your computer)
Customize the system. (Described in Section 4.4)
Configure and start your networking software. (Described in Section 4.5)
Run the User Environment Test Package (UETP) to test the system.
(Described in OpenVMS System Manager’s Manual, Volume 2: Tuning,
Monitoring, and Complex Systems)
Decompress the system libraries using LIBDECOMP.COM. (Described in
Section 4.7)
Remove unwanted files from the system disk using the OpenVMS tailoring
utility. (Described in Chapter 10)
Install layered products.
Back up the system disk after you have customized it. (Described in the
upgrade and installation supplement for your computer)
Run AUTOGEN after the system has been running for at least 24 hours to
collect feedback information. (Described in Section 4.11)
After Installing the OpenVMS VAX Operating System 4–9