Technical data

11 Connect the Ground Cable — Dual Host Only
To connect the ground cable:
1. Find the ground cable (12–13756–A8) shipped with your system. It has
a ground-lead terminal on each end.
2. Feed the ground cable under host A from the back or side and up
through the opening in the front as shown in Figure 42.
Figure 42: Connecting the Ground Cable
MLO-004028
Feed Cable Under System
and Through Opening
3. Locate the Ground Wire Out bolt on host A. It is under the handle on
the power supply as shown in Figure 42.
4. Remove the nut from that bolt.
5. Slide the ground-lead terminal over the bolt.
6. Replace and tighten the nut.
7. Repeat steps 2 through 6 for host B using the other end of the ground
cable.
VAX 4000 Model 300 Installation 61