Technical data

The diagnostic software is on a tape cartridge labeled MV DIAG CUST
TK50. Your system Troubleshooting and Diagnostics manual tells you how
to run the diagnostic software.
You should now read your system Operation manual to learn how to use the
system. You must know how to operate the system controls and the ISE or
tape drive before you install system software or run diagnostic software.
If you have factory-installed software on your system, see Appendix A for
the startup procedure. Otherwise, install the software that you ordered
with your system.
NOTE: Systems with VMS factory-installed software have a yellow sticker
on the front panel of the ISE containing that software.
VAX 4000 Model 300 Installation 69