Installation Guide

ManualsBrandsVaxcel Lighting ManualsIndoor Ceiling FixturesGrafton 2 Light Flush Mount Indoor Ceiling Fixture with Frosted Glass Shade - 13 Inches Wide

Fig.1

Screw

Key Hole Slot

1. Attach the two long screws to the holes on the mounting

strap, thread them in part way: 2 to 3 turns only.

2. Attach the mounting strap to the outlet box using two short

mounting screws.

3. Pull out the source wires from the outlet box. Make wire

connections using wire nuts as follow:

---Connect the hot wire (usually black insulation) from the fixture

to the black wire from the power source.

---Connect the neutral wire (usually white insulation) from the fixture

to the white wire from the power source.

---Attach the fixture grounding wire (usually green insulation or bare

wire) to the mounting strap with the green grounding screw. Then

connect it to the house grounding wire with the wire nut.

Carefully put the wires back into the outlet box.

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

C0082

Outlet Box

House Grounding Wire

Wire Nut(E)

Long Screw(D)

Ceiling Pan

Socket

Coupling

Lock Nut(H)

Threaded Pipe(J)

Glass Shade

Metal Pad(K)

Lock Nut(H)

Decorative Cup(G)

Cap(F)

Mounting Strap(A)

Green Grounding Screw(C)

Short Mounting Screw(B)

Bulb Type A Max.60W

(not included)

Lock Nut (H)

Washer (I)

Threaded pipe (J)

Short Mounting

Screw (B)

Green Grounding

Screw (C)

Wire Nut (E)

Mounting Strap (A)

Long

Screw (D)

Metal Pad (K)

Decorative Cup (G)

Finial (F)

Washer (I)

141108

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

Hardware Package (included):

Turn off the power at fuse or circuit box.

Installation Steps

Summary of content (2 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS C0082 WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS. Hardware Package (included): Mounting Strap (A) Finial (F) Fig.
PAGE 2
4. Attach the ceiling pan to the mounting strap by inserting two long screw heads into the key holes, and rotate the ceiling pan until it locks in place. Then secure the screws tightly. (See Fig.1) 5. Screw the threaded pipe into the coupling, then secure it with a washer and a lock nut. NOTE:Depth of threaded pipe may need to be adjusted to properly fit glass shade, decorative cup and finial. 6. Install bulbs (not included). See relamping label at socket area or packaging for maximum allowed wattage. 7.