Installation Sheet

ManualsBrandsVaxcel Lighting ManualsLightingMillie Single Light 6" Wide Mini Pendant

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THIS INSTRUCTION.

P0248

171107

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

Hardware Package (included):

Turn off the power at fuse or circuit box.

Installation Steps

Mounting Screw (C)

Lock Nut (F)

Wire

Connectors

(E)

Mounting Strap (A)

Fixture Mounting

Screw (D)

Green Grounding

Screw (B)

Canopy Kit

Glass Shade

Bolt Nut(G)

Turn on the power at fuse or circuit box.

Bulb Type A Max.60W

(Not Included)

Outlet Box

Mounting Strap(A)

Green Grounding Screw (B)

Lock Nut(F)

Mounting Screw(C)

Fixture Mounting

Screw(D)

Wire Connectors(E)

Strain Relief (H)

C(3")

D(3/8")

B(9")

Figure.1

2. Measure the desired length of the cable (A) from the canopy to the top

side of the cap nut and leave an additional 9" of cable (B) above the

canopy (include the canopy). Then cut off the unnecessary cable.

(See Figure 1)

3. Adjust strain relief at 9" position from the top of the cord.

4. Mark the 3" of cord (C) from the top of the cord (B). Use

a knife to peel off the insulation of the cord (C) carefully

to expose the 3 wires on the inside. (See Figure 1)

Caution: Cutting too deep may cut off the three inside

wires and destroy the insulation surface of the three

inside wires.

5. Peel off the wire from the top about 3/8" long(D) to expose the

copper wires.

6. Attach the mounting strap to the outlet box by using two mounting

screws.

7. Pull out the outlet wires and the house grounding wire from the

outlet box. Make wire connections using the wire nuts:

a. The black wire from the fixture to the black wire from the power source.

b. The white wire from the fixture to the white wire from the power source.

c. The green grounding wire from the fixture to the green grounding wire

from power source. Carefully put wires back into the outlet box.

8. Pull the cord ( A ) down slightly until the strain relief touches the hex nut.

Note: Adjusting the strain relief of the canopy can decrease or

increase the length of cord that is exposed.

9. Attach the fixture canopy to the mounting strap by inserting the screws, and

secure it with two bolt nuts.

10. Install a bulb (not included).See relamping label at socket area or

packaging for maximum allowed wattage.

11. Turn

on the power at the main fuse or circuit breaker box.

Cable

Flat HeadScrew

driver(H)

Fastening cable by screwing plastic headless screw, using flat head

screwdriver(H).

Flat HeadScrew

driver(H)