Installation Sheet

ManualsBrandsVaxcel Lighting ManualsLightingBeloit Single Light 12" Wide Pendant with A Glass Shade

1. Rod Connections:

a. Thread the fixture wire from the fixture through the lower rod,then

secure the lower rod onto fixture using the threaded pipe.

b. Thread the fixture wire through the middle rod, and then secure the

middle rod onto the lower rod using the threaded pipe.

c. Thread the fixture wire through the upper rod, and then secure the

upper rod onto the middle rod using the threaded pipe.

Note: Length adjustable from 17” to 59”. Use fewer rods if

shorter length is desired.

Thread the fixture wire through the canopy kit, then secure the rod

assembly to the set nipple of the canopy kit.

3. Attach the mounting strap to outlet box by using two mounting screws.

4. Pull out the source wires from the outlet box. Make wire connections

using wire connectors as follows:

---Connect the smooth-coated wire (marked) from the fixture to the

black wire from the power source.

---Connect the ribbed-coated wire (unmarked) from the fixture to the

white wire from the power source.

---Attach the fixture grounding wire to the mounting strap with the green

grounding screw. Then connect it to the house grounding wire with a

wire connector.

Carefully put the wires back into the outlet box.

5. Attach the canopy kit to the mounting strap by inserting the fixture

mounting screws, then secure it with two bolt nuts.

6. Attach the glass shade to fixture, then secure it with the socket

ring.

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THIS INSTRUCTION.

P0273

181206

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

Hardware Package (included):

Turn off the power at fuse or circuit box.

Installation Steps

Mounting Screw (C)

Lock Nut (F)

Wire Connector (E)

Mounting Strap (A)

Fixture Mounting

Screw (D)

Green Grounding

Screw (B)

Canopy Kit

Outlet Box

House Grounding Wire

Wire Connector (E)

Lock Nut(F)

Mounting Strap (A)

Green Grounding Screw (B)

Mounting Screw (C)

Upper Rod

Middle Rod

Lower Rod

Threaded Pipe

Fixture Wire

Fixture Mounting Screw(D)

Fixture Grounding Wire

Fixture

Glass Shade

Socket Ring

Bulb Type A Max.60W

(Not Included)

Set Nipple

Bolt Nut(G)

Summary of content (2 pages)

PAGE 1
P0273 ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THIS INSTRUCTION.
PAGE 2
Fig. 1 7. Install bulb (not included). See relamping label at socket area or packaging for maximum allowed wattage. Support Brace Outlet Box 8. Angled mounting recommended for a vaulted or angled ceiling. (See Fig. 1) Canopy Coupling Kit Turn on the power at fuse or circuit box. The following parts are available for re-order if damaged or missing.