Installation Sheet

Outlet Box
House Grounding Wire
Wire Connector (F)
Fixture Wire
Fixture Grounding Wire
Mounting Strap (A)
Green Grounding Screw (C)
Mounting Screw (B)
Nipple (G)
Canopy (H)
Top Loop (J)
Hex Nut (D)
Washer (E)
Collar (I)
Loop Lock (K)
Chain (L)
Loop
Loop Lock
181107
1. Attach the nipple to the mounting strap, then secure it with a washer
and hex nut.
2. Attach mounting strap to the outlet box using two mounting screws.
3. Rod Connections:
a. Thread the fixture wire from the fixture through the lower rod, and
then secure the lower rod onto fixture using the threaded pipe.
b. Thread the fixture wire through the middle rod, and then secure
the middle rod onto the lower rod using the threaded pipe.
c. Thread the fixture wire through the upper rod, and then secure
the upper rod onto the middle rod using the threaded pipe.
Note: Length adjustable from 11" to 60". Use fewer rods if
shorter length is desired.
4. Secure the top loop to the nipple.
5. Choose the length of the chain you need, then weave the fixture
wire and the fixture grounding wire through the chain, collar and
canopy.
6. Connect one end of the chain with the loop by using a loop lock.
7. Connect the other end of the chain with the top loop by using
another loop lock.
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THIS INSTRUCTION.
P0282
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Hardware Package (included):
Turn off the power at fuse or circuit box.
Installation Steps
Upper Rod
Threaded Pipe
Middle Rod
Lower Rod
Mounting Strap (A)
Mounting Screw (B)
Green Grounding
Screw (C)
Hex Nut (D)
Wire Connector (F)
Nipple (G)
Canopy (H)
Collar (I)
Washer (E)
Top Loop (J)
Loop Lock (K)
Chain (L)
Light Fixture
Bulb A Max.60W
(not included)