Installation Guide

ManualsBrandsVaxcel Lighting ManualsLightingGrant 7" Wide Mini Pendant

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

1. Attach threaded pipe (E) to the mounting

strap (A), then secure it with a washer (G)

and hex nut (F).

2. Attach the mounting strap (A) to the outlet box by

using two mounting screws (B).

3. Secure the top loop (I) to threaded pipe (E).

4. Take a glass panel and gently slide the narrow

side of the glass panel down into the metal frame

in place, secure it by pressing the clips from both

top and bottom sides. (See Fig.1 & Fig.2) Repeat

with other panels.

Turn off the power at fuse or circuit

box.

Installation Steps

Glass Panel

Fig.1

Clip

Fig.2

Clip

200928

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

P0346

Mounting Strap (A)

Wire Connector (D)

Collar (J)

Washer (G)

Mounting Screw (B) Green Ground

Screw (C)

Hex Nut (F)

Canopy (H) Top Loop (I)

Threaded Pipe (E)

Loop Lock (K)

Chain (L)

Hardware Package(inculded):

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

Outlet Box

Housing Ground Wire

Wire Connector (D)

Fixture Wire

Fixture Ground Wire

Mounting Strap (A)

Green Ground Screw (C)

Mounting Screw (B)

Threaded Pipe (E)

Hex Nut (F)

Washer (G)

Top Loop (I)

Main Fixture

Canopy (H)

Loop

Loop Lock (K)

Collar (J)

Chain (L)

Medium Base Bulb Max.40W

(not included)

Glass Panel (M)

Summary of content (2 pages)

PAGE 1
P0346 ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
5. Choose the length of the chain (L) you need, then weave the fixture wire and the fixture ground wire through the chain (L), collar (J) and canopy (H). 6. Connect one end of the chain (L) with the loop by using a loop lock (K). 7. Connect the other end of the chain (L) with the top loop (I) by using another loop lock (K). 8. Thread the fixture wire and fixture ground wire through the top loop (I), threaded pipe (E) and mounting strap (A). 9.