Installation Sheet

ManualsBrandsVaxcel Lighting ManualsLightingMilano 1 Light Mini / Monorail Pendant with Canopy

1. Thread the cord through the canopy and Strain Relief.

Measure the desired length of the cord (A) from the

canopy to the glass and Leave additional 9" cord (B)

above the canopy(include the canopy).Then cut off the

unnecessary cord.(See Fig.1)

2. Adjust Strain Relief at 9" position from the top of the cord.

3. Mark the 3" cord (C) from the top of the cord (B). Use a

knife to peel off the insulation of the cord (C) carefully

to show the 3 inside wires out. (See Fig. 1)

Caution : Cutting too deep may cut off three inside wires

and destroy the insulation surface of the three

inside wires.

4. Peel off the 3 wires from the top about 3/8" long(D) to expose

the copper for wiring.

5. Unscrew the screws from the canopy.

6. Mount mounting strap securely to ceiling box with 2 mounting

screws through slot in mounting strap.

7. Make wire connections with wire nuts:

---Connect White Wire from the fixture to White Wire from

power source with a wire nut.

---Connect Black Wire from the fixture to Black Wire from

power source with a wire nut.

---Connect Green Grounding Wire from the fixture to Green

Grounding Wire from power source with a wire nut.

Carefully tuck wires back into the ceiling box.

8. Pull the cord ( A ) down slightly until the strain relief touches

the hex nut. Attach the canopy to the mounting strap by

using 2 screws.

Note: Adjust the strain relief can decrease or increase the

length of cord exposing outside.

9. Install a bulb.(please do not exceed the maximum capacity

that is recommended on the package.)

10.Turn on the power at fuse or circuit box.

Mounting Strap

Mounting Screw

Screw

Wire Nut

Strain Relief

Canopy

Cord (A)

Hex Nut

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

WARNING:

TO AVOID RISK OF ELECTRIC SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

NOTE: 1. Before installing, consult local electrical codes for wiring requirements.

2. Please read the instructions carefully before you install this fixture. If you

are not familiar with installations, please consult the qualified electrician.

PD30110/30119/30127/30128/30129/30131/30133/30135/30137/30139

Installation Steps

Fixture Wire

Bulb

C(3")

D(3/8")

B(9")

FIG.1

051226