Specification Sheet

200716

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

Hardware Package (included):

Mounting Screw (B)Cross Bar Unit (A) Wire Connector (C)

T0016

WARNING: Turn off the main power at circuit breaker before installing fixture.

AVERTISSEMENT: Coupez la source d’alimentation principale au panneau

central de disjoncteurs avant d’installer le luminaire.

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ

AND SAVE THESE INSTRUCTIONS.

IMPORTANT:

The sensor has an excellent photocell function

to enable the light to turn on at dusk and off at

dawn automatically.

Wire Connector (C)

House Grounding Wire

Outlet Box

Mounting Screw (B)

Green Grounding Screw

Headless Screw

Cross Bar Unit (A)

Fixture Wire

Fixture Grounding Wire

Bulb Type A Max.60W

(not included)

Backplate

Photocell

Fixture

Bolt Nut

Rubber Pad

Shade

Socket Ring

PAGE 1
T0016 ASSEMBLY AND INSTALLATION INSTRUCTIONS W WARNING: Turn off the main power at circuit breaker before installing fixture. AVERTISSEMENT: Coupez la source d’alimentation principale au panneau central de disjoncteurs avant d’installer le luminaire. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
Installation steps Turn off the power at fuse or circuit box. 1. Unscrew the two bolt nuts. Remove the two rubber pads and the cross bar unit (A) from the backplate. 2. Attach the cross bar unit (A) to the outlet box using two mounting screws (B). Adjust the length of the preinstalled headless screws if necessary. Note: Make sure that the headless screws are lined up horizontally to make the fixture level. 3. Pull out the source wires from the outlet box.
PAGE 3
The following parts are available for re-order if damaged or missing.