Installation Sheet

ManualsBrandsVaxcel Lighting ManualsIndoor Wall LightsPolk 12" Tall Swing-Arm Wall Sconce with Instalux Motion Technology

Back Plate

Mounting Screw (B)

Green Grounding

Screw (E)

Wire Connector (F)

170918

Page 1

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

W0259 / W0260

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

Hardware Package (included):

Lock Nut

(D)

Headless Screw (C)

Ball Nut (G)

Socket Ring

Inner Shade

Bulb Type A Max.60W

(not included)

Socket

Holder

Turn off the power at fuse or circuit box.

Ball Nut (G)

This FIXTURE can be mounted in two ways.

Option 1: (Hard Wire Installation)

Assembly Instructions:

Strain Relief (H)

Pipe Strap (N)

Dry Wall Screw (O)

Bushing (P)

Anchor (L)

Hex Nut (J)

Washer (K)

Threaded Pipe (M)

Outlet Box

Wire Connector (F)

Green Grounding Screw (E)

Headless Screw (C)

Cross Bar(A)

Mounting Screw (B)

Lock Nut(D)

Fixture Grounding Wire

House Grounding Wire

Fixture Wire

Swivel (I)

Rocker Arm

Outer Shade

Cross Bar(A)

Summary of content (4 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS W0259 / W0260 WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
1. Thread two headless screws through the cross bar, then secure them with four lock nuts (two on each side of the cross bar). Adjust the length of the headless screws if necessary. Note: Make sure that the headless screws are lined up horizontally to make the fixture level. 2. Attach the cross bar to the outlet box by using two mounting screws. 3. Pull out the source wires from the outlet box.
PAGE 3
7. Thread the plug cord through two holes of the strain relief. Pull the plug cord down until the strain relief touches the back plate. Note: Adjust the strain relief can decrease or increase the length of the exposed plug cord. 8. Cut any excess plug cord leaving 10 inches from the back plate. Slit the plug cord apart in 5 inches. Peel off insulation of the two wires in 5/8 inch. (See Fig.2) Fig.2 Plug Cord Back Plate 5" 5/8" 9. Pull out the source wires from the back plate.
PAGE 4
The following parts are available for re-order if damaged or missing.