Installation Sheet

ManualsBrandsVaxcel Lighting ManualsIndoor Wall LightsVilo Single Light 19" Tall Wall Sconce with Inner And Outer Glass Shades

1. Attach the mounting plate to the wall.

a) If the wall material is wood:

Attach the mounting plate to the outlet box by using two mounting screws, then secure the dry wall screws through

the set holes to the wall.

b) If the wall material is cement:

Place the mounting plate to the outlet box and mark the target on the wall from the set hole for drilling two holes.

Remove the mounting plate. Drill the holes and thread the anchors into the holes, then attach the mounting plate to

the outlet box by using two mounting screws. Secure the dry wall screws through the set holes into the anchors.

Glass bracket

Bulb T10 Max.75W

(not included)

Back Plate

Mounting Screw (B)

Headless Screw (D)

Mounting Plate (A)

House Grounding Wire

Green Grounding Screw (C)

Fixture Grounding Wire

Wire Connector(E)

Outlet Box

Fixture Wire

181012

Mounting Screw (B)

Green Grounding

Screw (C)

“ L ” Screwdriver (F)

Wire Connector (E)

Mounting Plate (A)

Headless Screw (D)

“ L ” Screwdriver (F)

Anchor (H)

Dry Wall Screw (G)

Interior Glass Shade (J)

Exterior Glass Shade (I)

Anchor (H)

Dry Wall Screw (G)

Figure.1

Interior Glass Shade

Slot

Fixture

arm

Slot

Socket Spring

Page 1

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

W0048 / W0124 / W0310

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

Hardware Package (included):

Assembly Instructions:

Turn off the power at fuse or circuit box.

Summary of content (2 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS W0048 / W0124 / W0310 WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
. Pull out the source wires from the outlet box. Make wire connections using wire connectors as follows: ---Connect the black (hot) wire from the fixture to the black (hot) wire from the power source. ---Connect the white (neutral) wire from the fixture to the white (neutral) wire from the power source. ---Attach the fixture grounding wire to the mounting plate with the green grounding screw. Then connect it to the house grounding wire with a wire connector.