Installation Sheet

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

W0389

Mounting Plate Unit (A) Wire Connector (C)Mounting Screw (B)

Set screw (D)

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ

AND SAVE THESE INSTRUCTIONS.

Fixture Ground Wire

Wire Connector (C)

Mounting Plate Unit (A)

House Ground Wire

Green Ground Screw

Outlet Box

Fixture Wire

Set Screw (D)

Backplate

Glass Holder

Max.60W T10 Bulb

(not included)

Glass Shade

Mounting Screw (B)

Turn off the power at fuse or circuit box

Installation Steps

Remove the mounting plate unit (A) from the backplate by disassemblying the set screws (D).

2. Attach the mounting plate unit (A) to the outlet box by using two mounting screws (B).

Note: Make sure that two set holes are lined up horizontally to make the fixture level.

3. Pull out the source wires from the outlet box. Make wire connections using wire connectors (C) as follows:

• Connect the hot wire (black insulation) from the fixture to the black wire from the power source.

• Connect the neutral wire (white insulation) from the fixture to the white wire from the power source.

• Attach the fixture ground wire (bare wire) to the mounting plate unit (A) with the green ground screw, then

depending on local code, connect it to the house ground wire with the wire connector (C).

Carefully put all of the wires back into the outlet box.

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

210223

PAGE 1
W0389 ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO TO SHUT SHUT OFF OFF TOAVOID AVOID RISK RISK OF OF ELECTRICAL ELECTRICAL SHOCK, BE SURE TO POWER INSTALLINGOR OR SERVICING THIS FIXTURE. POWERBEFORE WHILE INSTALLING SERVICING THIS FIXTURE. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
4. Attach the backplate of the fixture to the mounting plate unit (A) by aligning holes, secure the two set screws (D) from the side hole of the backplate into the hole of the mounting plate unit (A). 5. Install the bulbs (not included). Check relamping label at socket area or packaging for maximum wattage allowed. 6. Rotate the glass shades onto the glass holders. Turn on the power at fuse or circuit box The following parts are available for re-order if damaged or missing.