Installation Sheet

PAGE: 6 / 10
(For downrod mount only):
Insert and tighten the two collar
screws. Slide lock pin into hanger
pin until it is locked into position.
Fig.9
Lock Pin
Collar
Screws
Fig.15
Fig.15a
Antenna
DIP Switch
Transmitter
Receiver
There is a frequency-setter respectively in
the transmitter and receiver. This "DIP
Switch" is a 4 key unit (Fig. 15). All keys
were set at "ON" position in the beginning.
Set the keys to a different code. Make sure
the same numbered keys are switched "ON"
for both DIP Switches (Fig. 15a). Take note
that the "ON" position may have different
orientation in each.
Code example:
1-ON 2-OFF 3-ON 4-OFF
on both DIP Switches.
Fig.16
Move Ground Wires (a), Outlet Box wires (b), and
Motor Wires (c) away from the center of the Hanger
Bracket. Then slide Receiver through Hanger
Bracket as shown, Antenna end first, until it is
centered. Finally, cut Motor Wires (c) to length
needed for connections.
Antenna
Receiver
Hanger
Bracket
a.
b.
c.
Fig.12
(For downrod mount only):
Tighten the ground wire screw.
Slide the pin in. Slide the hanger ball
up into position.
Fig.13
(For downrod mount only):
Tighten the hanger ball screw to the
downrod.
(For downrod mount only):
Thread the motor wires and safety
cable through the canopy as shown.
Then thread the wires and safety cable
through the hanger ball.
Fig.11
Hanger
Ball
Canopy
Motor
Wires
(For downrod mount only):
Thread the motor wires and safety cable
through the downrod stand cover as
shown. Then slide cover down so it
rests on the housing.
Fig.10
Downrod
Stand
Cover
Motor
Wires
Slot
Chip
Hanger Bracket
Fig.14
Hang the fan on Hanger Bracket, and make
sure the slot of hanger ball is snapped into
the chip of Hanger Bracket exactly.
Note: For slope ceiling installation, make sure
the slot of hanger ball and the chip of hanger
bracket face down.
Safety
Cable
F A N C O
171120