Installation Guide

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
H0057
Loop
Parts:
Bulb Type B Max.60W
(not included)
Parts Number (4673MM)
Mounting Strap (A)
Mounting Screw (B)
Green Grounding
Screw (C)
Wire Nut (D)
Canopy (I)
Loop Lock (K)
Chain (L)
130116
Outlet Box
House Grounding Wire
Wire Nut (D)
Fixture Wire
Fixture Grounding Wire
Mounting Strap (A)
Green Grounding Screw (C)
Mounting Screw (B)
Nipple(G)
Canopy (I)
Top Loop (H)
Hex Nut (E)
Washer (F)
Collar (J)
Loop Lock (K)
Loop Lock (K)
Chain (L)
Hex Nut (E)
Washer (F)
Nipple(G)
Top Loop (H)
Collar (J)
Top Assembly
Main Fixture Body
Pipe
Candle Tube
1. Attach nipple to the mounting strap, then secure
it with a washer and hex nut.
2. Attach the mounting strap to the outlet box by
using two mounting screws.
3. Secure the pipe onto the main fixture body, secure
the top assembly into the pipe. Pull any excess
cord through the top assembly and the pipe.
4. Hook one end of the chains onto the top assembly.
Note: Adjust the top assembly, make sure that the
chain and hook are lined up perpendicular.
5. Attach the candle tube into the socket on the
main fixture body, as shown.
6. Choose the length of the chain you need, then
weave the fixture wire and the fixture grounding
wire through the chain. Then connect one end
of the chain with the loop by using the loop lock.
7. Secure the top loop to nipple.
8. Thread the fixture wire and fixture grounding
wire through the collar, canopy, top loop, nipple
and mounting strap.
9. Connect the other end of the chain with the top
loop by using the loop lock.
10. Pull out the outlet wires and the house grounding
wire from the outlet box. Make wire connections by using the wire nuts:
---The smooth wire (marked) from the fixture to the black wire from the power source.
---The ridged wire (unmarked) from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the mounting strap with the green grounding screw. Then
connect it to the house grounding wire with a wire nut.
Carefully put the wires back into the outlet box.
11. Attach the canopy to the mounting strap by inserting the top loop, then secure it with the collar.
12. Install bulbs(not included). See relamping label at socket area or packaging for maximum allowed
wattage.
13. Turn on the power at the main fuse or circuit breaker box.
Chain
Hook