Installation Guide

H0115
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTES: 1.Before installing, consult local electrical codes for wiring and grounding requirements.
2.READ AND SAVE THESE INSTRUCTIONS.
Socket Ring
Glass Shade
Mounting Screw
Nipple(-a)
Mounting Strap
Green Grounding Screw
Hex Nut
Wire Nut
Washer
Outlet Box
Canopy
Loop
House Grounding Wire
Nipple(-b)
Chain
Fixture Grounding Wire
Collar
Top Loop
Loop Lock
Loop Lock
Fixture Wire
Glass Holder
Upper Fixture
Plastic Pad
Coupling(-a)
Hex Nut
Metal Pad
Plug
Main Fixture
1.Attach the nipple(-a) to the mounting strap, then secure it with
a washer and a hex nut.
2.Attach the mounting strap to the outlet box by using two
mounting screws.
3.Secure the top loop to nipple(-a).
4.Carefully secure the upper fixture to the main fixture by screwing
the nipple(-b) into the coupling(-a) and secure it with the metal
pad and the hex nut.
5.Secure the loop to the nipple(-b) by using the plastic pad and the
plug.
6.Screw nipple(-c) into the coupling(-b),then attach the cap to the
coupling(-b) by inserting nipple(-c) and secure it with the finial.
7.Choose the length of the chain you need, then weave the
fixture wire and the fixture grounding wire through the chain,
collar and canopy.
8.Connect one end of the chain with the loop by using a loop lock.
9.Connect the other end of the chain with the top loop by using
another loop lock.
10.Thread the fixture wire and fixture grounding wire through the
top loop,nipple(-a) and mouting strap.
11.Pull out the outlet wires and the house grounding wire from
the outlet box. Make wire connections using the wire nuts:
---The smooth wire (marked) from the fixture to the black wire
from the power source.
---The ridged wire (unmarked) from the fixture to the white
wire from the power source.
---Attach the fixture grounding wire to the
mounting strap with the green grounding
screw.Then connect it to the house
grounding wire with a wire nut.
Carefully put the wires back into the outlet box.
12.Attach the canopy to the mounting strap by
inserting the top loop, then secure it with the collar.
13.Attach the glass shades to the glass holders,then secure them
with the socket rings.
14.Install bulbs (not included). See relamping label at socket area
or packaging for maximum allowed wattage.
15.Turn on the power at the main fuse or circuit breaker box.
Nipple(-c)
Cap
Finial
Coupling(-b)
Nipple(-b)
Bulb Type A Max.100W
(not included)
Contents of Spare Parts:
Chain
(1 PC)
(X-CNDC-40)
Glass Shade
(5 PC)
(948255)
Assembly Kit
(1 SET)
(X-CNDC-40)
141114