Installation Guide

ManualsBrandsVaxcel ManualsChandeliersVaxcel Lighting Grafton 3 Light 37-1/2" Wide Single Tier Chandelier with Glass Shades

1. Rod Connections:

a. Thread the fixture wire from the fixture through the lower rod,

and then secure the lower rod onto fixture using the threaded pipe.

b. Thread the fixture wire through the middle rod, and then secure the

middle rod onto the lower rod using the threaded pipe.

c. Thread the fixture wire through the upper rod, and then secure the

upper rod onto the middle rod using the threaded pipe.

Note: Length adjustable from 28-1/4" to 82-1/4". Use fewer

rods if shorter length is desired.

2. Thread the fixture wire through the coupling kit, collar,

canopy, then secure the rod assembly to the coupling

kit using set screw.

3. Thread the fixture wire through the threaded pipe,

hex nut and mounting strap. Install the hex nut onto

one end of the threaded pipe leaving about 3/8”

(10mm) thread exposed. Install same end of

threaded pipe by screwing into coupling kit,

secure threaded pipe by tightening hex nut.

4. Attach the threaded pipe to the mounting

strap, then secure it with hex nut.

5. Attach the mounting strap to outlet box by using two mounting screws.

6. Pull out the source wires from the outlet box. Make wire connections using wire nuts as follows:

---Connect the smooth-coated wire (marked) from the fixture to the black wire from the power source.

Collar (H)

Canopy (J)

Outlet Box

House Grounding Wire

Wire Nut (E)

Threaded Pipe (C)

Mounting Strap (A)

Green Grounding Screw (F)

Hex Nut(B)

Mounting Screw (D)

Upper Rod

Middle Rod

Lower Rod

Threaded Pipe

Fixture Wire

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

H0133 / H0134

Glass Shade(J)

Glass Holder

Socket

Socket Ring

Bulb Type A Max.100W

(Not Included)

Coupling Kit (G)

Set Screw

Fixture Grounding Wire

Hex Nut (B) & Washer(I)

Threaded Pipe

Mounting Screw (D)

Hex Nut (B)

Wire Nut (E)

Mounting Strap (A)

Threaded Pipe (C)

Green Grounding

Screw (F)

Coupling Kit (G)

Collar (H)

141126

Fixture

Washer (I)

Canopy (J)

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

Hardware Package (included):

Turn off the power at fuse or circuit box.

Installation Steps

Summary of content (2 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS H0133 / H0134 WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
---Connect the ribbed-coated wire (unmarked) from the fixture to the Fig. 1 white wire from the power source. ---Attach the fixture grounding wire to the mounting strap with the green Support Brace grounding screw. Then connect it to the house grounding wire with a wire nut. Carefully put the wires back into the outlet box. Outlet Box 7. Attach the canopy to the mounting strap, and secure it with collar. Canopy 8. Attach the glass shades onto the glass holders, secure them with socket rings.