Installation Sheet

AS S E MB LY AND INS TAL L ATION
INS TR UC TIONS
P0283 / P 0284
Turn off the power at fuse or circuit box.
Installation Steps
Turn on the power at fuse or circuit box.
Cord
Set Screw (E)
Outlet Box
Green Ground Screw
Mounting Screw(C)
Wire Connector (D)
A
C(3")
D(3/8")
B(9")
Figure.1
Flat Head Screw driver
Cord Grip(G)
Strain relief(F )
Canopy(I)
Glass Shade(H)
Bolt Screw(B)
LED 5.5W
181115
Mounting Plate (A) Mounting Screw (C)Bolt Screw (B)
Canopy Screw (E)Wire Connector (D)
x3
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTES: 1. Before installing, consult local electrical codes for wiring and ground requirements.
2. Read and save this instruction.
1. Assembling the main fixture.
a. Lift up glass shade(H) and screw in bolt screws(B) into the glass fitter.
b. Adjust the cord length by means of cord grip(G) and strain relief(F) until the
desired hanging height is met. You may need to cut the excess wire. You will
need at least 9 inches of wire to work with. Prepare wire by stripping 3/4 in.
of insulation from wire ends using wire strippers (not included). See Figure.1.
c. Attach the mounting plate(A) to the outlet box using two mounting screws(C).
2. Connecting the wires.
Make wire connections using the wire connectors(D):
a. The black wire from the fixture to the black wire from the power source.
b. The white wire from the fixture to the white wire from the power source.
c. Loop the supply ground wire around the ground screw on the mounting plate
and tighten it in place. Connect the fixture ground wire to the supply ground
wire using a wire connector(D).
3. Mounting the fixture.
a. Carefully arrange excess wiring and wire connectors (D) within canopy(I) at
top of fixture.
b. Align holes in edge of canopy with holes at ends of mounting plate(A), then
secure with canopy screws(E).
Mounting Plate (A)
not included
Hardware Package (included):