Installation Sheet

ManualsBrandsVaxcel ManualsShop All VaxcelVaxcel Lighting Astor Single Light 3" Wide Pendant with A Glass Shade

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

P0295

WARNING:

AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

181126

Turn off the power at fuse or circuit box.

Installation Steps

1. Rod Connections:

a. Thread the fixture wire from the fixture through the lower rod, then secure

the lower rod onto fixture using the threaded pipe.

b. Thread the fixture wire through the middle rod, and then secure the middle

rod onto the lower rod using the threaded pipe.

c. Thread the fixture wire through the upper rod, and then secure the upper rod

onto the middle rod using the threaded pipe.

Note: Length adjustable from 16-5/8" to 58-5/8". Use fewer rods if shorter

length is desired.

2. Thread two fixture mounting screws to the mounting strap, then secure them with

two lock nuts. Adjust the length of the fixture mounting screws if necessary.

3. Attach the mounting strap to outlet box by using two mounting screws.

4. Thread the fixture wire through the canopy, then secure the upper rod to the

canopy with the nipple.

5. Pull out the source wires from the outlex box. Make wire connections using

wire connectors as follows:

---Connect the hot wire (usually black insulation) from the fixture

to the black wire from the power source.

---Connect the neutral wire (usually white insulation) from the fixture to the

white wire from the power source.

---Attach the fixture grounding wire (usually green insulation or bare wire) to the

mounting plate with the green

grounding screw, and then connect it to the house grounding wire with the wire

connector.

Carefully put the wires back into the outlet box.

Hardware Package (included):

Fixture Mounting screw (E)

Mounting Screw (B) Green Grounding Screw (C)

Wire Connector (D)

Lock Nut (F)

Mounting Strap (A)

Ball Nut (G)

Outlet Box

House Grounding Wire

Wire Connector (D)

Fixture Grounding Wire

Green Grounding Screw (C)

Fixture Mounting Screw (E)

Mounting Screw (B)

Canopy

Ball Nut (G)

Nipple

Upper Rod

Threaded Pipe

Middle Rod

Threaded Pipe

Nipple

Glass Holder

Glass Shade

Bulb Type T Max.60W

(not included)

Lower Rod

Lock Nut (F)

Mounting Strap (A)

Summary of content (2 pages)

PAGE 1
P0295 ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
6. Attach the canopy to the mounting strap by inserting the fixture mounting screws, then secure it with two ball nuts. 7. Install a bulb (not included). See relamping label at socket area or packaging for maximum allowed wattage. 8. Attach the glass shade to the glass holder directly. 9. Angled mounting recommended for a vaulted or angled ceiling. (See Fig. 1) Fig.1 Support Brace Out Box Canopy Coupling Kit Turn on the power at fuse or circuit box.