Installation Guide

ManualsBrandsVaxcel ManualsShop All VaxcelVaxcel Lighting Ainslie Single Light 12" Wide Pendant

191205

1. Unscrew two ball nuts (H), remove mounting strap (A) from canopy.

2. Loosen the plastic headless screw on the canopy by using a

flathead screw driver (I) .

3. Push the guy wires up into the canopy.Press bushing up and

pull the guy wires down.

NOTE:The guy wires and power cord should be approximate

height and power cord is some what loose to prevent the power

cord wire load.

4. Thread the cord through the canopy and strain relief (G). Measure

the desired length of the cord (a) from the canopy to the glass

shade and leave additional 9" cord (b) above the canopy

(include the canopy), then cut off the unnecessary cord.

(See Fig.1)

5. Adjust strain relief (G) at 9" position from the top of the cord.

6. Mark the 3" cord (c) from the top of the cord (b). Use a knife

to peel off the insulation of the cord (c) carefully to show the

3 inside wires out. (See Fig. 1)

Caution : Cutting too deep may cut off three inside wires

and destroy the insulation surface of the three inside

wires.

7. Peel off the 3 wires from the top about 3/8" long (d) to

expose the copper for wiring.

8. Attach the mounting strap

(A)

to outlet box by using two mounting

screws

(B)

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THIS INSTRUCTION.

P0315

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

Hardware Package (included):

Turn off the power at fuse or circuit box.

Installation Steps

Fig.1

b(9")

c(3")

d(3/8")

Mounting Screw (B)

Wire Connector (F)

Strain Relief (G)

Mounting Strap (A)

Fixture Mounting Screw (E)

Green Ground Screw (C)

Lock Nut (D)

Ball Nut (H)

Flat Head Screwdriver (I)

Canopy

Ball Nut (H)

Cord (a)

Guy Wire

Rubber Ring

Hex Nut

Strain Relief (G)

Mounting Strap (A)

Green Ground Screw (C)

Lock Nut (D)

Mounting Screw (B)

Wire Connector (F)

Fixture Mounting Screw (E)

Outlet Box

Plastic Headless

Screw

Glass Shade

Medium Base Bulb

Max.60W (not included)

Summary of content (2 pages)

PAGE 1
P0315 ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THIS INSTRUCTION.
PAGE 2
9. Pull out the source wires from the outlet box. Make wire connections using wire connectors (F) as follows: a. Connect the hot wire marked "L" from the fixture to the black wire from the power source. b. Connect the neutral wire marked "N" from the fixture to the white wire from the power source. c. Connect the copper wire or green wire marked " " from the fixture to the mounting strap (A) by securing it with the green ground screw.