Installation Guide (P0324)

191205
1. Unscrew two ball nuts (H), remove mounting strap (A) from canopy.
2. Loosen the plastic headless screw on the canopy by using flathead
screw driver (I) .
3. Thread the cord through the canopy and strain relief (G). Measure the
desired length of the cord (a) from the canopy to the glass shade and
leave additional 9" cord (b) above the canopy (include the canopy),
and then cut off the unnecessary cord. (See Fig.1)
4. Adjust strain relief (G) at 9" position from the top of the cord.
5. Mark the 3" cord (c) from the top of the cord (b). Use a knife
to peel off the insulation of the cord (c) carefully to show the
3 inside wires out. (See Fig. 1)
Caution : Cutting too deep may cut off three inside wires
and destroy the insulation surface of the three inside wires.
6. Peel off the 3 wires from the top about 3/8" long (d) to expose
the copper for wiring.
7. Attach the mounting strap
(A)
to outlet box by using two mounting
screws
(B)
.
8. Pull out the source wires from the outlet box. Make wire connections
using wire connectors
(F)
as follows:
a. Connect the hot wire marked "L" from the fixture to the black wire
from the power source.
b. Connect the neutral wire marked "N" from the fixture to the white wire
from the power source.
c. Connect the copper wire or green wire marked " " from the fixture
to the mounting strap (A) by securing it with the green ground screw.
The green ground wire marked " " from the fixture to the green
ground wire from power source.
Carefully put wires back into the outlet box.
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THIS INSTRUCTION.
P0324
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
Hardware Package (included):
Turn off the power at fuse or circuit box.
Fig.1
Installation Steps
Canopy
Ball Nut (H)
Cord (a)
Fixture Wire
Hex Nut
Strain Relief (G)
Mounting Strap (A)
Green Ground Screw (C)
Lock Nut (D)
Mounting Screw (B)
Wire Connector (F)
Fixture Mounting Screw (E)
Outlet Box
a
c(3")
d(3/8")
b(9")
Plastic Headless
Screw
Mounting Screw (B)
Wire Connector (F)
Strain Relief (G)
Mounting Strap (A)
Fixture Mounting Screw (E)
Green Ground Screw (C)
Lock Nut (D)
Ball Nut (H)
Flat Head Screwdriver (I)
Glass Shade
Fixture
Socket
Socket Ring
Medium Base Bulb
Max.60W (not included)

Summary of content (2 pages)